Table of Contents
Advertisement
Assembly
6
• Fit a retainer with lock nut
onto the end of the screw
and to the inside of a
side rail.
Hint: A lock nut has been factory assembled to the retainer.
During shipment, the lock nut may have fallen out of the
retainer. If it has, please fit it into the hexagonal hole in the
retainer so that the rounded side of the lock nut faces out.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to fasten the screw in the other
end of the front tube and side rail, using the remaining
retainer with lock nut.
Retainer
with Lock Nut
Rounded Side
M4 Lock Nut - 2
(Inside Retainer)
Shown Actual Size
Press
Tab
7
• Position the assembly face down, as shown.
• While pressing the tab on each end of the kickstand, insert
the kickstand into the receptacle in each side rail, as
shown.
• Push the kickstand into the receptacles until the
tabs "snap" into place. Make sure you hear a "snap" on
each side.
• Pull the kickstand to be sure it is secure in the receptacles.
5
Kickstand
Press
Tab
Receptacles
Advertisement
Table of Contents
