Table of Contents
Advertisement
Section 3 - MAINTENANCE
3.1
INTRODUCTION
To retain the quality of the mower,
use genuine
SNAPPER replacement
parts only. Contact a local
SNAPPER dealer for parts and service assistance.
For the correct part or information
for a particular
mower, always mention model and serial number.
3.2
SERVICE - AFTER FIRST 5 HOURS
3.2.1.
CHANGE ENGINE OIL
This engine is equipped with two oil drain plugs. One
drain plug is located on the bottom of the engine and
requires a 5/16" allen wrench to remove. The other
is located adjacent
to the oil filter. It requires
a
14mm socket to remove.
The simplest way to drain the oil is to tilt the mower
on it's side (carburetor side up). Remove the oil fill
cap and allow the oil to drain from the filler tube into
a shallow pan. Refer to the Engine Owner's Manual
for details regarding
oil specifications,
oil and oil
filter change intervals.
WARNING
DO NOT attempt any maintenance,
adjustments
or
service with engine and blade running. STOP engine
and blade. Disconnect
spark plug wire and secure
away from spark plug. Engine and components
are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
3.2.2. GREASE LEVEL IN TRANSMISSION
The
transmission
requires
no
lubrication
or
maintenance. If transmission
leaks or malfunctions,
return machine to an authorized Snapper dealer for
repair.
3.2.3. WHEEL DRIVE CONTROL
The wheel drive control requires periodic adjustment
to maintain proper drive function. The adjustment is
performed with the thumb screw located on the right
handle
and requires
no tools.
Refer to Section
"WHEEL DRIVE CONTROL ADJUSTMENT".
OIL FILTER (Turn
Counter-Clockwise
To Remove)
FIGURE 3.1
Advertisement
Table of Contents
