When unpacking, check to make sure all the parts shown on the parts List on page 11 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Make sure the Laminator has completely cooled before touching it and stor- ing it. store idle laminating equipment out of reach of children and other untrained persons. Laminating equipment is dangerous in the hands of untrained users. For technical questions, please call 1-800-444-3353 SKU 92500 PAGE 3...
Keep the power Cord away from heat, oil, sharp edges, or moving parts. Replace damaged power Cords immediately. Damaged Power Cords increase the risk of electric shock. For technical questions, please call 1-800-444-3353 SKU 92500 PAGE 4...
Maintain labels and nameplates on the Laminator. These carry important infor- mation. If unreadable or missing, contact Harbor Freight Tools for a replacement. Always place the Laminator on a dry, flat, level, sturdy non-flammable work surface capable of supporting the weight of the Laminator and any additional accessories.
Your tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the following illustration. (see 3-prong plug and Outlet.) For technical questions, please call 1-800-444-3353 SKU 92500 PAGE 6...
5.1 – 7.0 7.1 – 12.0 12.1 – 16.0 16.1 – 20.0 TABLe A * Based on limiting the line voltage drop to five volts at 150% of the rated amperes. For technical questions, please call 1-800-444-3353 SKU 92500 PAGE 7...
Page 8
Double Insulated Canadian Standards Association Underwriters Laboratories, Inc. Volts Alternating Current Amperes n 0 xxxx/min. No Load Revolutions per Minute (RPM) For technical questions, please call 1-800-444-3353 SKU 92500 PAGE 8...
Page 9
Place the object to be laminated (i.e., paper, card, etc.) between the two layers of laminating film, and center the object on the laminating film. Adjust the Adjustable Front Guide (6) according to the width of the object being laminated. (see Figure D.) For technical questions, please call 1-800-444-3353 SKU 92500 PAGE 9...
Glass Fuse (not included). Then, replace the Fuse Cap. (See Assy. Diagram.) All maintenance, service, and repairs not listed in this manual are only to be at- tempted by a qualified technician. For technical questions, please call 1-800-444-3353 SKU 92500 PAGE 10...
Rear Guide Platform Green LED Light 3.15A/250V Fuse FRONT VIeW ReAR VIeW Note: Some parts are shown for illustration purposes only, and are not available individu- ally as replacement parts. For technical questions, please call 1-800-444-3353 SKU 92500 PAGE 11...