Advertisement
SERVICE AND ADJUSTMENTS
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake pedal fully and set parking brake.
Place gearshift lever in neutral position.
• Place attachment clutch in "DISENGAGED"
position.
•
Turn ignition key to "STOP" and remove key.
• Ensure the blades and all moving parts have completely stopped.
• Disconnects_ark__ugwirefromsparkp_ugandp_acewirewhereitcannotcomeincontactwithp_ug_
TO REMOVE
MOWER
(See Fig. 18)
•
Place attachment clutch in "DISENGAGED"
position.
•
Lower attachment lift lever to its lowest position.
•
Remove mower belt from engine pulley (M).
•
Remove retainer spring (K), slide collar (L) off and push
housing guide (P) out of bracket.
•
Remove clutch cable spring (Q) from idler arm (R).
•
Disconnect front link (E) from mower - remove retainer
spring and washer.
•
Go to either side of mower and disconnect mower
suspension arm (A) from chassis and rear lift link (C)
from rear mower bracket (D) - remove retainer springs
and washers.
•
Go to other side of mower and disconnect the suspen-
sion arm and rear lift link.
&
CAUTION: After rear lift links are dis=
connected,
the attachment
lift lever
will be spring loaded. Have a tight grip
on lift lever when changing position
of
the lever.
IMPORTANT:
IF AN ATTACHMENT OTHER THAN THE
MOWER
IS TO BE MOUNTED
ON THE TRACTOR,
REMOVE THE FRONT LINK (E) AND REAR LIFT LINKS
(C) FROM TRACTOR AND HOOKTHE CLUTCH SPRING
(Q) INTO THE CABLE GUIDE ON FRONT EDGE OF
LOWER DASH.
TO iNSTALL
MOWER
(See Figs. 18-23)
Be sure tractor is on level surface and engage parking
brake.
•
Lower attachment lift lever to its lowest position.
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
NOTE: Be sure mower side suspension arms (A) are point-
ing forward before sliding mower under tractor.
•
Slide mower under tractor until it is centered under
tractor.
•
Slide mower out from under right side of tractor.
Fig. 18
03042
16
Advertisement
