Final Assembly - Murray 20646X9A Instruction Book

PREPARATION
HOW TO MOUNT THE GRASS BAG
1. To mount the grass bag on the mower,
raise the rear door. Hold the handle of the
grass bag. Put the grass bag in the
operaling posi_on (Figure 12). Lower the
rear door.
IMPORTANT: Make sure the hooks, on each
side of the frame assembly, are mounted
on the pivot rod.
A WARNING: Do not use the grass
bag unless the cover is In the op
erating postlon.
Handle
Rear Door
MountFrame
HooksTo PivotRod
Figure 12
HOWTO EMPTYTHE GRASS BAG
WARNING: Before you remove
the grass bag, stop the engine.
A efore you remove any grass from the mower housing,
disconnect the wire from the
spark plug.
1, Hold the rear door. Raise the rear door to
a verlical position (Figure 12).
2. Lift the frame assembly over the two
handle notches,
3. Open the top covar (Figure 13). Empty the
grass from the grass bag.
4. To mount the grass bag on the mower, see
"How To Mount The Grass Bag'.
Top Cover
Figure 13
FINAL ASSEMBLY
Before you use the mower, check the
assembly of the wheels, the handle, and the
F- 98534
controls. M ake sure all the fastenersare tght,
Make sure the throttle controland the engine
stopleverwork correctly.
15