Sears LXI series 934.44817390 Owner's Manual page 11

Use this connection if your cable system connects
directly to your TVCR without a converter box.
With this connection you 1) can use your TVCR
Remote Control to select channels 2) program one
or more unscrambled channels for unattended
recording.
From Cable System
75-ohm
Coaxial Cable
(Not supplied)
ANT_ r
I:flq i :l 1|_El I ll_Ujl [_o] p]_
When using an external input signal, connect the
audio/video cable to the AUDIO IN, VIDEO IN
jacks.
Note: Disconnect all cables from the AUDIO IN
and VIDEO IN jacks to record TV programs.
If your cable service supplies you with a converter
box you can use the basic connection shown here.
f (Not supplied) From Cable System
--_T__._?6IN)/ CATVBox (Notsgpplied,
I
I ,.°,.u°.,°°, / I
With this connection you can record and view any
channel including scrambled channels. However
channel selection must be made at the cable com-
pany converter box. This means that channels
cannot be changed using the TVCR Remote Con-
trol. Unattended recording is limited to one chan-
nel at a time.
TO RECORD AND VIEW A SCRAMBLED/UN-
SCRAMBLED CHANNEL
1. Set the TVCR channel selector to the output
channel of the Cable Converter Box. (Ex. CH3)
2. Select the channel to be recorded or viewed on
the Cable Converter Box.
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC
that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building as close to the point of cable entry as practical.
-11 -