Operating Controls And Functions - Sears LXI series 304.43010000 Owner's Manual

OPERATING CONTROLS AND FUNCTIONS
-FRONT PANEL-
-REMOTE CONTROL-
.... f .... i
1 2 3 4 5
1. MENU button- Press to display the menu
on the TV screen.
2. VOLUME _ buttons- Press to control
the volume level.
Press to determine the setting mode from
the menu on the TV screen. (only the
VOL • button)
Press to select or adjust from a particular
menu. (for example: Language Selection,
Channel Presetting, Closed Caption
Selection, Picture Adjustment, V-CHIP Set
Up.)
3. CHANNEL _JV buttons- Press to select
memorized channel.
Press to select the setting mode from the
menu on the TV screen.
Press to select item you want to adjust in
the picture control mode.
4. POWER button- Press to turn the TV ON
and OFE
5. Infrared Sensor Window- Receives the
infrared control signals from the remote
control unit.
6. CHANNEL NUMBER button- Press two
digits to directly access the desired chan-
nel. Remember to press a "0" before a
single digit channel.
+100 button- Press to select cable chan-
nels higher than 99.
7. MUTE button- Press the MUTE button to
turn off the sound portion of the TV pro-
gram. (Volume level display turns LIGHT
RED from LIGHT BLUE.) Press the
MUTE button again or press the
VOL(ume) • or • button to restore
sound.
-REAR PANEL-
k
8. CHANNEL RETURN button- Press this
button to go back to the previously
viewed channel. For example, pressing
the CHANNEL RETURN button once will
change channel display from CH 3 (pre-
sent channel) to CH 10 (previously
viewed channel), and pressing it a second
time will return from CH 10 to CH 3.
9. DISPLAY button- Press to display the
channel number on the screen. If you
press it again, the channel number will
disappear.
10.SLEEP button- Press the SLEEP button
to display the sleep timer and start the
function. The shut off time can be deter-
mined by the number of times you press
the button. (0, 10, 20, 30,..90, 0 minutes)
11. ANT(enna). IN jack- Connect to an
antenna, cable system, or satellite sys-
tem.
12.AC cord- Connect to a standard AC out-
let (120V/60Hz).
Note: Unwrap the AC cord co_
from the backcover before plugging the
cord into an AC outlet.
11
IllO[_HIIh:tlllll_[elll=l=ll-lr'_lBl=l-'ll_',.T_ " -
Slide the battery compartment cover on the
remote unit,
Insert 2 "AA" penlight batteries into battery
compartment in the direction as indicated by
the polarity (+ / -) markings. Batteries
installed with incorrect polarity may damage
the remote unit.
Replace the cover.