Wheel Kit Installation - Generac Power Systems SE10000 Owner's Manual

Generac Portable Products S E10000 G enerator
WHEEL KIT INSTALLATION
You will need a 13mm metric box, open end or socket
wrench to install this kit.
Install Wheel Kit as follows: (Figure 3)
1 Place the bottom of the generator cradle on a flat,
even surface. It may help to raise the cradle on
temporary blocks.
2. Slide axle through both axle mounting brackets on
cradle frame.
3. Slide spacer over each end of axle.
4. Install the wheel. Secure wheel on axle with
retaining pin and washer. Be sure to install the
wheel with the raised hub inboard.
5 Install other wheel in the same manner.
6. Secure the vibration mount on the support leg
with lock nut, washer, and 30mm capscrew.
Fasten the support leg to the bottom of the
generator cradle, using 20mm capscrews, lock
washers and flat washers.
7. Position the handle below the muffler bracket on
the engine side of the generator. Attach the
handle with 45mm capscrews and lock nuts.
8 Recheck all nuts to make sure they are tight and
secure. Remove the temporary blocks.
Handle
45mm Capscrew
Axle
Locking
Nut _
Suppo_ Leg
Spacer
Washer
Vibration
Mount _ I
/
Retaining Pin
_ Flat Washer
/
M8 Flat _ Lock Washer
--Washer _
3gram 2Omm Capscrew
Capscrew
/
5