Flashing Display Lights - GE GSD3300D00WW Owner's Manual

Operation of electronic models (model GSD4000 Only)
Using the Dishwasher Door
door must be closed and locked into place to select a LOADSELECTIONor an OPTION.
Ifthe door is opened during a cycle and left open, the dishwasher will beep once every 30 seconds until the
.... door is c osed and atched into p ace.
Start
Close and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins and
approximately 60 seconds later the wash action begins.
NOTE:The dishwasher remembers your last cycle so you don't have to reprogram each time. When
the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON
and display the last settings you selected.
If you don't want to change any of the settings, simply touch the START/RESET pad to begin
the cycle.
Also, if a power failure occurs, NORMAL and HEATEDDRY will automatically be programmed.
Make any new selections and touch the START/RESET pad to begin the cycle.
Cleon
This light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened.
Flashing Display Lights
Lights What It Means What To Do
This is normal.
The START/RESET pad
has been pressed.
Allow the dishwasher to drain and reset before you start a new
wash cycle.
CLEAN
PLUS A
BEEPING
SOUND
Control Error
Pressthe START/RESET p ad to turn off the beeper. If the CLEAN
light continues to flash, call for service.
Control Error
Pressthe START/RESET p od to turn off the beeper and the
dishwasher will attempt to reset. Restart the wash cycle.
If this error continues, turn off the power to the dishwasher at
the circuit breaker for :30seconds. Try the dishwasher again.
If the error is still present, call for service.
PLUS A
BEEPING
SOUND
10