Instructions For Daily And Periodic Maintenance; Service, Spare Parts And Guarantee - Makita DCS 430 Owner's And Safety Manual

Instructions
for
daily and periodic maintenance
To ensure long life. prevent damage and ensure the full functioning of the safety features the following maintenance must be
performed regularly. Guarantee claims can be recognized only
if this work is performed regularly and properly. Failure to perform
the prescribed maintenance work can lead to accidents!
Perform the following servicing work daily after use. Make a habit of it, it does not require much time and your saw will always
function properly.
Possibly hidden faults can be detected in this manner before causing expensive and annoying interruptions of your work. In case
you should detect a fault in the safety equipment when performing daily servicing, the saw must not be used before elimination
of the fault. The user of the chain saw must not perform maintenance work which is not described in the instruction manual. All such
work must be carried out by a MAKITA service center
Genera 1
~ ~~
Before each start
~~~
Dayli servicing
Every week
. Every 3 months
Annually
Storage
Chain saw
Saw chain
Chain brake
Guide bar
Saw chain
Guide bar
Chain lubrication
Chain brake
Chain catcher
OFF switch,
Safety locking button,
Throffle lever
FueVoil tank
cap
Air filter, prefilter
Chain brake
Guide bar
Guide bar support
Idle speed
Fan housing
Starter cable
Carburetor interior
Chain brake
Spark plug
Muffier
Chain guide
Suction head
Fuel, oil tanks
Chain saw
Chain saw
Guide badchain
Fuel, oil tanks
Carburetor
Clean exterior, check for damage. In case of damage,
have repaired
by
a qualified service center immediately
Sharpen regulary. replace in good time
Have inspected regularly at an authorized service center
Turn over to ensure even wear of bearing surfaces
Replace in good time
Inspect for damage and sharpness
Check chain tension
Check for damage
Functional check
Functional check
Check for damage
Functional check
Check for tightness
Clean
Clean, check for visible damage or cracks
Clean, in particular the oil guide groove
Check for damage, clean oil intake bore
Check that a sufficient difference is existing between
idlind speed and engaging speed, to ensure that the chain
is in standstill while the engine is idling.
Clean to ensure proper air cooling
Check for damage
Clean (remove filter cover for access)
Clean the brake band (sawdust. oil)
Check and replace if necessary
Check tightness of mounting, clean spark arrester screen
Check
Replace
Clean
Check at an authorized service centre
,
Clean exterior. check for damage. In case of damage,
have repaired by a qualified service center immediately
Demount, clean and oil slightly
Clean
the
guide groove
Empty and clean
Page
24-25
19
24
19
23
19
22-23
27
26
21
21,26
23
28
.
28
27
26
27
26
25
26
21
~
25
Service, spare parts
and
guarantee
Maintenance and repair
The maintenance and repair of modem engines as well as all safety devices require qualified technical training and a special
workshop equipped with special
tools
and testing devices.
We therefore recommend that you consult a MAKITA service center for all work not described in this instruction manual.
The MAKITA service centers have all the necessary equipment and skilled and experienced personnel, who can work out cost-
effective solutions and advise you in all matters.
Please contact the general agent or importer indicated on the back cover of this Instruction Manual, who will gladly provide you with
the address of your nearest MAKITA service center.
29