LG Monitor Installation Manual page 35

4-6. Setting the Installation Menu (2/2)
Menu
Signage Mode
Operation
15Min Force Off
4 hours off
Wake On LAN
Total Set ID
DPM
Software Update
Power On Status
Input Source
Change
Menu Display
OSD Display
Min Volume
Max Volume
Power On
Default
Input Source
Volume
Aspect Ratio
Intelligent Auto
Factory Reset
Decide to work all functions of 'Signage Mode Operation' or not.
Turns off the monitor if there is no input for more than 15 minutes.
"No" is the recommended default value setting.
Turns off the monitor if there is no input on the remote control for
more than four hours."No" is the recommended default value setting.
Turns on the monitor remotely using LAN.
Sets the maximum value for picture IDs.
Enters energy saving mode if there is no input signal.
Sets whether to use NSU (Network Software Update).
Decide to select working status of Monitor Set when turn on main
power.
Decide to change input source or not by setting 'Input Source
Change' as Yes(Change possible) or No(Change impossible).
MENU key does not work if 'Menu Display' is set to No.
Decide to display OSD or not by setting 'OSD Display' as Yes(Mark)
or No(No Mark).
Decide 'Min Volume' between changing range 0 to 100.
Decide 'Max Volume' between changing range 0 to 100.
With the power turned on, you can set the 'Input Source' and
'Volume' options.
Set whether it is turned on by the set input source or by the last
stored input source.
This sets whether to apply the Volume Level or not when the power
is turned on.
With the power turned on, you can set the 'Aspect Ratio' option with
the pre-defined value.
If the setting is Yes, Display is automatically arranged through
resolution size when you change the resolution at the first.
If it is set to No, 'Factory Reset' under OPTION is disabled.
Description