Table of Contents
Advertisement
Bluetooth Setup
Press
to enter Bluetooth mode.
1
Turn the volume knob to select [SETTINGS], then press to enter.
2
Turn the volume knob to make a selection, then press to confirm.
3
See table below for selection.
■ ■
Repeat step 3 until the desired item is selected/activated.
■ ■
Press
to return to the previous item.
■ ■
Hold
to finish the procedure.
4
To cancel the Bluetooth mode, press
.
■ ■
Item
Selectable setting (Preset: *)
PAIRING
DEVICE SEARCH Registers a Bluetooth device (pairing). (For details, see
PHONE SELECT Selects a cell-phone connection. (For details, see
AUDIO SELECT
Selects a Bluetooth audio player connection. (For details, see
S-DVC SELECT
(For details, see
page
22.)
DEVICE DELETE Cancel registration of the Bluetooth device.
1. Turn the volume knob to select the Bluetooth device, then press to confirm.
2. Turn the volume knob to select "YES", then press to confirm.
DETAILED SET
PIN CODE EDIT
Specify the PIN code required when registering this unit using the Bluetooth device. By default, "0000" is
specified.
1. Turn the volume knob to select the number.
To move to the next digit, press ¢.
■ ■
To delete the last digit, press 4.
■ ■
2. Press the volume knob to register a PIN code
AUTO ANSWER OFF: Does not answer the phone call automatically. ; 0: Automatically answers the phone call at once. ;
1 – 8 * –99: Automatically answers the phone call after lapse of 1 – 99 seconds.
RECONNECT
ON *: Automatically reconnects the selected Bluetooth device when radio wave becomes strong enough,
even after it is disconnected. ; OFF: Cancels.
When this function is turned ON, the Bluetooth device is reconnected if it has been disconnected by
■ ■
selecting [PHONE SELECT]/ [AUDIO SELECT].
BT HF/AUDIO
FRONT *: Outputs audio from the front speakers. ; ALL: Outputs audio from the all speakers.
CALL BEEP
ON *: Sets whether to output a beep from the speaker when a call comes in. ; OFF: Cancels.
BT F/W UPDATE Display the firmware version and update the firmware.
MIC GAIN
1 — 20 * — 30: Adjust the sensitivity of the microphone for telephone call or adjusts the voice of the caller.
NR LEVEL
–1 — 0 * — +1: Reduce the noise generated by the surrounding environment without changing the
built-in microphone volume or adjusts the voice of the caller when it is not clear. Setting to "+" increases the
noise reduction.
EC LEVEL
–1 — 0 * — +1: Adjust the level of echo cancellation. Setting to "+" increases the echo cancel reduction.
24
English
page
22.)
page
22.)
page
22.)
CONTENTS
25
English
Advertisement
Table of Contents
