First Act Amplifier MA002 Instruction Manual

1
6
1. INPUT JACK
Connect guitar or other instrument here (1/4" jack).
2. VOLUME
Controls output level of amplifier.
3. LED
Light indicates power on/off.
4. GAIN
Controls input level. Increasing gain adds distor-
tion, or an overdriven rock tone;
decreasing gain produces a cleaner sound.
INSTALLING BATTERIES
The MA002 Amplifier operates with two 9-volt alkaline batteries. Two battery compartments can be found
on the back of the amp, on either side of the speaker.
Replace both batteries by following these steps:
Open the battery compartment door, pinch the tab, and pull the door to open.
To install a new battery, snap the +/- terminals of the battery into place on the connector pad.
Place the attached battery into the compartment.
Close the compartment door.
Do not mix old and new batteries. Do not mix alkaline standard (carbon-zinc) and rechargeable (nickel-
cadmium) batteries.
SPECIFICATIONS
Output Power:
4 watts RMS
Frequency Range:
60 Hz ~ 6 kHz
Speaker:
4" / 8W / 4 ohms
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
FACEPL ATE
2 3
BACKPL ATE
Input Sensitivity:
26 mV
Dimensions: (LxWxH)
8" x 3.25" x 7.5"
Weight:
3 lbs.
4
5. TONE
Turn right to add treble/reduce bass.
Turn left to add bass/reduce treble.
6. POWER
Turns amplifier on/off.
5
First Act
745 Boylston Street
Boston, MA 02116 USA
firstact.com