Table of Contents
Advertisement
About your LED LCD TV / Getting Started
PREPARATION OF
YOUR REMOTE
CONTROL
BATTERY INSTALLATION
A
Place the remote control face down, then open the
cover of the battery compartment.
B
Install two AAA batteries. (The + and - symbol of the
battery must match with the marks on the remote).
C
Close the cover of the battery compartment.
BATTERY CAUTION
Confirm there is no object between the remote control
and the remote sensor of the TV set.
Sunshine or other strong light will interfere with the
signal sent by the remote control. In this situation turn
the TV set to avoid the direct light source.
Do not put the remote control in direct heat or in a
damp place as you may damage the remote.
Please use two AAA 1.5V batteries. Do not mix battery
types. Install the batteries at the correct polarities. Do
not use rechargeable batteries. If your TV is to be stored
for a period of time, remove the batteries from the
remote control.
Getting Started
SETTING UP
LOCATION
You will need to place your TV near your plug socket
(so the power cable can comfortably reach) and within
reach of your aerial socket or extension lead.
CONNECTION
A
Insert your TV aerial lead into the Antenna input at
the side of the TV.
B
Insert the batteries into the remote control. Make
sure they are inserted the right way around,
matching the polarity as indicated inside the battery
compartment.
SWITCHING YOUR TV ON
A
Connect your TV to the mains electrical supply
Note: The red light at the bottom of the TV will be
on whenever the TV is in standby and there is power
to the TV.
B
Touch the POWER button on the right side of the TV
Digital LED LCD Television Instruction Manual EN-10
About your LED LCD TV
Advertisement
Table of Contents
