Fiesta ESD45055-BC301 Assembly Manual

Outdoor gas barbeque / grill

Advertisement

Quick Links

Please follow these instructions carefully. Much of
the hardware required to assemble this grill is in
an individually sealed bag that is identified with
respect to its application. These sealed bags will
be referenced in the appropriate assembly step.
Siga por favor estas instrucciones
cuidadosamente. Mucho del hardware requerido
para montar esta parrilla estÆ en un bolso
individualmente sellado que se identifique con
respecto a su uso. Estos bolsos sellados serÆ n
referidos al paso apropiado de la asamblea.
WARNING
!
Failure to follow all manufacturer's instructions
could result in serious personal injury and/or
property damage.
La falta de seguir las instrucciones de todo el
fabricante pod a dar lugar a daæos corporales
y/o a daæos materiales serios
!
CAUTION
Some parts may contain sharp edges- especially as
noted in manual!wear protective gloves if necessary.
Algunas piezas pueden contener los bordes
agudos ¡- especialmente segœn lo observado
en manual! guantes protectores del desgaste en
caso de necesidad .
CUSTOMER SERVICE
TOLL FREE 1-800-396-3838
Fiesta Gas Grills LLC
One Fiesta Dr., Dickson TN, USA 37055
Outdoor Gas Barbeque / Grill
Assembly Manual
Manual De la Asamblea
/
ADVERTENCIA
/
PRECAUCI"N
SERVICIO DE CLIENTE
PEAJE LIBREMENTE 1-800-396-3838
THIS GRILL IS FOR OUTDOOR USE
ONLY
Caution:
Read and follow all Saftey Statements, Assembly
Instructions, and Use and Care Manual Directions
before attempting to assemble and cook.
Installer / assembler:
Leave these instructions with consumer.
To Consumer:
Keep this manual for future reference.
ESTA PARRILLA EST¡ PARA EL USO
AL AIRE LIBRE SOLAMENTE
Precauci n: Lea y siga todas las declaraciones de
Saftey, instrucciones de montaje, y uso y cuide las
direcciones manuales antes de procurar montar y
cocinar.
Instalador/ensamblador: Deje estas instrucciones
con el consumidor.
Al Consumidor:
Guarde este manual para la referencia futura.
NO TOOLS REQUIRED!
NINGUNAS HERRAMIENTAS
REQUIRIERON
MODEL/MODELO -
ESD45055-BC301
1

Advertisement

Table of Contents
loading

Summary of Contents for Fiesta ESD45055-BC301

  • Page 1 . CUSTOMER SERVICE SERVICIO DE CLIENTE TOLL FREE 1-800-396-3838 PEAJE LIBREMENTE 1-800-396-3838 Fiesta Gas Grills LLC One Fiesta Dr., Dickson TN, USA 37055 Assembly Manual Manual De la Asamblea THIS GRILL IS FOR OUTDOOR USE ONLY Caution:...
  • Page 2: Wheels And Leg Extensions

    START COMIENZO Install Wheels Instalará las ruedas Axle árbol Place Axle Through Wheel Center. Push Axle into Clip Until it Snaps in Place. Acomoda el árbol a través de centro de la rueda. Empuje el árbol en el clip hasta que se encaja a presión en lugar. Install Leg Extensions.
  • Page 3: Chassis Assembly

    Install Cross Member as Shown. Instalar a miembro cruzado según lo mostrado. Left End Bottom Support ayuda del fondo del extremo izquierdo Wing Nut La Nuez del ala Channel Clamp Installed Abrazadera Del Canal Instalada 1/4" - 20 X 2-1/2" Carriage Bolt 1/4”...
  • Page 4: Front Panel And Back Support

    FRONT PANEL AND BACK SUPPORT PANEL DELANTERO Y AYUDA TRASERA Install Front Panel. Instalar el Panel Delantero Install Back Support Instale detrás la ayuda Locate hardware in back support bag pack. Localice el hardware en paquete trasero del bolso de la ayuda. 1/4-20 J BOLT 1/4 PERNO De J 1/4-20 Wing Nut...
  • Page 5: Console And Base

    Install Console as Shown. Instalar consola según lo mostrado. Soup Can not Supplied with Grill. La sopa no puede provisto de la parrilla. CONSOLE AND BASE BASE Y CONSOLA Installation of Console to Leg Assembly. Instalación de la consola al ensamblaje de la pierna. Install Base Casting and Grease Cup Clip Instalar el bastidor bajo y engrase el clip de la taza Attach Screw as Shown.
  • Page 6: Burner And Igniter

    BURNER AND IGNITER HORNILLA Y ENCENDEDOR Install H Burner as Shown. Instalar hornilla de la H según lo mostrado. Hook Electrode wire to igniter using long (10") Jumper Wire. Hook Green ground wire to igniter. (any terminal on igniter) Enganche el alambre del electrodo al encendedor usando (10") el alambre de puente largo.
  • Page 7 TRAMPA DEL ESTANTE Y DE LLAMA Slide Shelf onto Legs. Tabs on Underside of Shelf will Snap into Notches as Shown. Resbale el estante sobre las piernas. Las tabulaciones en el superficie inferior del estante se encajarán a presión hacia muescas según lo mostrado.
  • Page 8: Side Burner Assembly

    SIDE BURNER ASSEMBLY ASAMBLEA LATERAL DE LA HORNILLA Install Side Burner Base Assembly and Valve Attachment. Instale la conexión lateral del ensamblaje y de la válvula de la hornilla. Slide Side Burner Base Assembly Over Legs Until Front Trim Snaps into Place.
  • Page 9 SIDE BURNER ASSEMBLY ASAMBLEA LATERAL DE LA HORNILLA Install Side Burner. Instalar la conexión lateral. Hook Electrode wire to igniter (using short (3") Jumper Wire if necessary). Hook Green ground wire to igniter. (Rear Side of Console) (remaining 2 terminals on igniter) Enganche el alambre del electrodo al encendedor usando brevemente (3") el alambre de puente (en caso de necesidad).
  • Page 10 Install Lid, Handle, Cooking Grid, Warming Rack, Hinge Clip, and Logo. Instale la tapa, manija, cocinando rejilla, el estante que se calienta, el clip de la bisagra, y la insignia. Use handle bag pack and Logo bag pack. El paquete del bolso de la manija del uso y el bolso de la insignia embalan.
  • Page 11: Tank Installation

    Insert Tank Bracket into Slot, Rotate 90 Degrees. Slide Down Over Tank Ring to Hold Tank in Place. Inserte el soporte del tanque en ranura, rote 90 grados. Resbale abajo sobre el anillo del tanque hacia el tanque del asimiento en lugar. IMPORTANT: Ensure hose assembly does not contact the casting, or any other parts which will get hot.

Table of Contents