Janome OC 6260 Instruction Book page 33

1
17
Auto
2
1 2 3
A
1
4
Step 1
Step 2
Step 3
Step 4
3
2
#17 Square buttonhole (Auto buttonhole)
Machine setting
1 Pattern
Foot
2
3 Thread tension
1 Mark the buttonhole position on the fabric. Pull the
button holder all the way out.
Draw the needle thread to the left through the hole on
2
the foot.
3 Place the fabric under the foot and lower the needle at
the starting point by turning the handwheel. Lower the
foot.
Button holder
1
Starting point
2
NOTE: You do not need to pull down the buttonhole
lever.
Depress the foot control and follow the steps below.
4
Step 1: Sew up the left row to the desired buttonhole
length and stop the machine. Press the reverse
stitch button.
Step 2: Depress the foot control again. The machine will
automatically tack and sew down the right row.
Stop the machine when you return to the starting
point. Press the reverse stitch button.
Step 3: Depress the foot control again. The machine will
sew the front bartack and stop automatically.
Step 4: After the buttonhole is completed, a blinking dot
will appear on the LED display. Raise the presser
foot.
NOTE: The blinking dot indicates that the buttonhole
length has been memorized. If you wish to alter
the stitch density, you need to re-select the auto
buttonhole and repeat the above steps with a
new stitch setting.
To sew buttonholes in the same size, simply
depress the foot control. Keep the foot control
depressed and the machine will sew the same
sized buttonhole and stop automatically.
You do not need to press the reverse stitch
button.
The LED display shows " 0 " while sewing.
#17
R: Automatic buttonhole foot
Auto
31