• Company names and product names appearing in this document are registered trademarks or trademarks of their respective owners. Additional Precautions • Unfortunately, it may be impossible to restore the contents of data that was stored in the iPad once it has been lost. Roland Corporation assumes no liability concerning such loss of data.
Before You Use VR-09 Editor (Connecting Via Wireless LAN) You’ll need to make the following preparations in order to use this app. Settings in VR-09 Editor If you connect using a USB cable, refer to p . 6 . Make the following settings in VR-09 Editor.
Page 5
Before You Use VR-09 Editor (Connecting Via Wireless LAN) If the screen indicates “No instrument found,” check the following points Points to check Reference Is the instrument powered-on? Is the wireless USB adapter (WNA1100-RL) connected to the instrument? For details on models that support wireless LAN...
Before You Use VR-09 Editor (Connecting Via a USB Cable) You’ll need to make the following preparations in order to use this app. Settings in VR-09 Editor Required Items Make the following settings in VR-09 Editor. You’ll need the following items in order to use this app.
(p. 13). Tapped to switch the display between the Organ Tone and the Synth Tone. Setup button Displays VR-09 Editor’s setup screen (p. 4). Percussion Used to turn percussion on/off and to change settings. Vibrato/Chorus Used to turn vibrato/chorus on/off for each part and to select the type.
About the Screen When “TRANSISTOR” Is Selected for Organ Type “TRANSISTOR” When is selected for Organ Type, the composition of the screen will change somewhat. Vibrato/Chorus Used to make global on/off settings for the parts. Harmonic bars The number of bars and the effects will change. The pedal part will disappear.
(p. 14). Tapped to switch the display between the Organ Tone and the Synth Tone. Setup button Displays VR-09 Editor’s setup screen (p. 4). Parts Here you can select the part that you want to edit (p. 10).
About the Screen Parts Here you can select the part that you want to edit. Part SELECT Part Status Indicates the status of the UPPER part or LOWER part. Here you can select the part that you want to edit. Indicate Tone assigned to the part Button...
About the Screen Partials Here you can turn partials on/off and select the partial that you want to edit. Partial SW Partial SELECT Turn each partial on/off. Select the partial that you want to edit. Button Explanation Button Explanation This partial is on. This partial is being edited.
About the Screen Parameters Here you can edit the Synth Tone parameters. The screen that’s shown will depend on the parameter select tab you’ve chosen. OSC/FILTER/AMP “OSC/FILTER/AMP” “LFO” This will appear if the parameter select tab is set to (p. 11). This will appear if the parameter select tab is set to (p.
[SYNTH] When used in combination with a Synth Tone, you can tap the The Organ Tone parameters will be sent from the VR-09 to VR-09 Editor. button to switch the display to the Synth Tone. The current Organ Tone parameter settings of the VR-09 will appear in VR-09 Editor.
[ORGAN] When used in combination with an Organ Tone, you can tap the The Synth Tone parameters will be sent from the VR-09 to VR-09 Editor. The button to switch the display to the Organ Tone. current Synth Tone parameter settings of the VR-09 will appear in VR-09 Editor.
A Tone you edit is temporary; it will be lost if you turn off the power or select another tone. If you want to keep a Tone you’ve edited, you must write the Registration. For details, refer to the VR-09 owner’s manual. MEMO You can’t save the Tone by operating VR-09 Editor. You’ll need to perform the save operation on the VR-09 itself.