Heated Handles - Husqvarna 555 Operator's Manual

Temperature 0° ° ° ° C or colder:
The intermediate wall is designed so it can be adjusted for
running in cold weather, so that preheated air from the
cylinder can pass into the carburettor space preventing
icing of the air filter, etc. Lift off the air filter to obtain better
access. Use a screwdriver to carefully knock away the
plug in the partition.
For temperatures below -5°C and/or in snow conditions a
special cover is available, which is mounted on the starter
housing.
Part number: 522 98 65-01.
These reduce the flow of cooling air and prevent large
amounts of snow from being sucked into the carburettor
space.
IMPORTANT! If the temperature rises above -5°C or 0°C
respectively, the starter housing cover MUST be
removed and the accompanying plug, art. no. 503 40
59-01 fitted in the hole in the partition wall. Otherwise
there is a risk of overheating, resulting in severe
damage to the engine.
MAINTENANCE

Heated handles

560XPG, 562XPG
On models with the model code XPG both the front
handle bar and the rear handle are equipped with
electrical heating coils. These are supplied with electricity
from a generator built into the chain saw.
When the switch is pushed upwards, the heat is switched
on. When the switch is pushed downwards, the heat is
switched off.
Electrical carburettor heating
560XPG, 562XPG
On models with the designation XPG there is an
electrically heated carburettor. Electrically powered
heating prevents ice formation in the carburettor. A
thermostat regulates the heating so that the carburettor
always has the right working temperature.
–
English 35