Recommended Original And Replacement Bar And Chain Combinations - Husqvarna 365 Operator's Manual

Recommended original and replacement bar and chain combinations

These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low
kickback performance requirements. However, for these models we recommend the following cutting equipment.
Bar
Length, inches Pitch, inch
15 3/8
16 3/8
18 3/8
20 3/8
24 3/8
28 3/8
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
0,050"/1,3 mm 72LP
0,058"/1,5mm H42/73LP
0,063"/1,6 mm 75LP
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries to the
!
user. Do not operate this saw unless you have extraordinary cutting needs and experience and specialized
training for dealing with kickback. Saws with significantly reduced kickback potential are available. Always
use the safest saw and cutting equipment applicable to your cutting need.
D
_
TECHNICAL DATA
Chain
Max nose radius
11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
11T Husqvarna H42 / EM S48 or Oregon 73LP / 73LG
72LG
EM S48/73LG
75LG
72V
73V
75V
L
– 37
English