Download Print this page

Field Controls CLEARWAVETM WATER CONDITIONER CW-HD-4 Installation Manual

Water conditioner

Advertisement

Quick Links

CLEARWAVE
The ClearWave
is the most advanced hi-tech computerized anti-scale device available today. It operates by using a
programmed 'chip' to constantly cycle through and induce over 200 different electro-magnetic low frequency wave pulses
into the water. These wave pulses produce water with remarkable anti-scale properties, without adding salts or chemicals,
at an operating cost for electricity of approximately $ 25.00 per year.
P
S
: 18 VAC, 25 Watts, .22 Amps
OWER
PECIFICATIONS
HOW IT WORKS
Pure water contains nothing but H
such as calcium and magnesium are the main components of hard water, and the cause of scale formation and other
problems.
There are three basic methods used to control the problem of hardness and specifically scale formation.
I
E
:
ON
XCHANGE
One method is to remove the calcium and magnesium from the water through ion exchange (the traditional water
softener). This method requires the use of a resin filled tank with a high concentration of salt ions. As the water flows
through the resin tank the salt ions (typically sodium) are exchanged for the calcium or magnesium ions. This lowers the
concentration of the minerals that cause scale and therefore inhibits scale formation.
C
A
:
HEMICAL
DDITION
A second method used to control hard water scale is the addition of chemicals (such as phosphates) to the water. These
materials chemically alter the scaling characteristics of the calcium or magnesium, allowing the concentration of the
minerals to stay the same while still reducing scale formation and its affects.
Both of the above methods require the use of consumable materials to change the makeup of the water. For these
devices to function properly, the homeowner must continuously replenish the salts or chemicals as well as perform
periodic maintenance on the equipment. In addition to these inconveniences, the chemicals and salts discharged into the
effluent water present problems downstream to the municipal water treatment facility and the environment. Many U.S.
cities have been enacting and/or evaluating environmental legislation to limit or reduce the levels of chemicals or salts
that result from these types of water treatment methods.
E
P
:
LECTRIC
OTENTIAL
A third method used to treat the hard water problems associated with scale utilizes changes in electrical potential in the
water to produce the affects of chemical addition. The electric potential applied changes the scaling characteristics of the
calcium or magnesium without the removal of these ions or the addition of chemicals.
Magnets
Bar magnets were the first types of equipment used to generate electric potential changes in water. Bar magnets have
been used with limited success to inhibit scale formation. The fixed magnetic field of a bar magnet creates electric
potential changes in the water only when the water moves through the magnetic field. Electromagnets function in much
the same way as bar magnets, but the magnetic field is created by passing a current through a coil, essentially creating a
more powerful fixed magnetic field. Inherently, fixed magnetic fields are limited to a narrow range of applications, pipe
sizes and water flow rates.
Permanent bar magnets and electromagnets have been promoted as a method of "treating" hard water, but they do not
treat the vast and complex array of mineral contents and concentrations found in water. Particles can also build up inside
the pipe where the magnet is placed, eventually causing blockage at the very point it is supposed to be doing its job.
Electrostatic Devices
Electrostatic devices create an electric potential in the water between two electrodes. One electrode is mounted in the
water stream in the center of the pipe housing, while the pipe itself acts as the other electrode. The device applies a
voltage across the two electrodes to create the electric potential in the water. This electrostatic approach was an
improvement upon the bar magnets and electromagnets, but increased the initial cost considerably while not dramatically
WATER CONDITIONER
MODEL CW-HD-4
0. But water, as it comes out of the ground, is rich in a multitude of minerals. Minerals
2

Advertisement

loading

Summary of Contents for Field Controls CLEARWAVETM WATER CONDITIONER CW-HD-4

  • Page 1 CLEARWAVE ™ The ClearWave is the most advanced hi-tech computerized anti-scale device available today. It operates by using a programmed ‘chip’ to constantly cycle through and induce over 200 different electro-magnetic low frequency wave pulses into the water. These wave pulses produce water with remarkable anti-scale properties, without adding salts or chemicals, at an operating cost for electricity of approximately $ 25.00 per year.
  • Page 2: Testing For Hardness And Iron Levels

    improving the range of effective conditions. ClearWave™ The ClearWave™ water conditioning system operates on similar principles as the magnets and electrostatic devices. But unlike those previously mentioned, the ClearWave™ uses microprocessor technology to electronically generate inaudible wave-forms which help keep calcium carbonate particles (scale) dissolved or suspended in water. With ClearWave™, the electric field generated is always being applied to the water, while a magnetic field relies on the movement of water to produce the electric potential changes.
  • Page 3: Properly Wrapping The Antennae

    Figure 1 Figure 1A can be replaced with 70 feet of 12Ga stranded wire. ROPERLY WRAPPING THE ANTENNAE The antenna wrap around the water pipe on each end of the ClearWave™ (see Figure 1). A minimum of seven fully wrapped coils of the antenna wire, with each coil wrapped tightly against the pipe and pressed snugly against each other is required for best results (see Figure 1A).
  • Page 4 time a functional problem is suspected, unplug the power supply, wait one minute then plug in the power supply again. Page 4...
  • Page 5 The performance of the ClearWave™is not affected by the direction or orientation of the unit. The unit NOTE: may be mounted to horizontal, vertical, or diagonally. The ClearWave™ can be used effectively on any type of water pipe; galvanized, copper, or plastic. NOTE: The ClearWave™...
  • Page 6 Page 6...
  • Page 7 _______________________________ _______________________________ _______________________________ _______________________________ _______________________________ _______________________________ _______________________________ _______________________________ _______________________________ _______________________________ _______________________________ ™ , visit the Field Controls web site at www.fieldcontrols.com. Page 7 Light Moderate Heavy Very Heavy (ppm-Parts Per Million) P/N 46302600 Rev. A...

This manual is also suitable for:

Clearwave cw-hd-4