Table of Contents
Advertisement
SeekTech
which contains all default and user‑defined frequencies�
Select frequencies within the Frequencies Menu to
appear in the Main Menu list� Deselect frequencies in
the Main Menu list to appear in the Frequencies Menu�
Use the Up and Down Arrow Keys
frequency and press the Select Key
or OFF� When enabled, a frequency will show an arrow
icon and will appear in the top level list of the Main
Menu� When disabled, the frequency will show an "X" �
User‑defined Frequencies
The ST‑33Q can accept 40 custom, user‑defined
frequencies that can be used in either Direct Connect
Mode or Inductive Clamp Mode� A user‑defined
frequency can be unselected on either list within a
mode without affecting the other mode�
Figure 26 – User‑defined Frequency Option
Select the User‑defined Frequency option
after selecting the Frequencies option
the Tools Menu
to add custom user‑defined or
factory‑installed frequencies (See Figure 26)�
The ST‑33Q will accept user‑defined frequencies
from 10 Hz to 490 kHz for North America models� For
European models, the ST‑33Q will accept user‑defined
frequencies from 10 Hz to 95 kHz� See the last page of
this Operator's Manual for a list of frequencies used by
common manufacturers�
Adding a User‑defined Frequency
To add a user‑defined frequency, select the User‑defined
Frequency option
after selecting the Frequencies
option
from the Tools Menu
selecting a the User‑defined frequency option, a screen
with six digit placeholders will appear (See Figure 27)�
Figure 27 – User‑defined Frequency Screen
16 - English
ST-33Q
®
to highlight a
to turn it ON
from
� After
Use the Frequency Key as a Left Arrow Key
all the way to the left of the screen to access a drop‑down
list of pre‑stored 3‑digit and 4‑digit frequencies� Use the
Up and Down Arrow Keys
When highlighted, press the Select Key
the selection (See Figure 28)�
Figure 28 – Stored User‑defined Frequencies
Use the Frequency Key
left and right arrow keys to move through each digit
placeholder� Use the Up and Down Arrow Keys
to increase and decrease the value of each digit� The
ST‑33Q will adjust the output frequency as each digit
is entered� This auto‑adjustment allows the tuning of
the target frequency for maximum signal at the receiver�
Press the Select Key
to confirm the frequency once
entered�
After pressing the Select Key
user‑defined frequency to the user‑defined frequency list
and the frequency will automatically appear, selected
for use, in the Main Menu� If enabled, user‑defined
frequencies will show a "+ sign" next to it in the Main
Menu (See Figure 29)�
Figure 29 – Enabled User‑defined Frequency
Editing a User‑defined Frequency
To edit a user‑defined frequency, press the Main Menu
Key
to access the top‑level menu� Use the Up and
Down Arrow Keys
frequency that requires editing� When highlighted, press
the Frequency Key
�
If the frequency that requires editing does not appear
in the top‑level menu, select the Frequencies option
from the Tools Menu
User‑defined Frequency option
and Down Arrow Keys
to move
to scroll through the list�
to confirm
and the Power Key
, the ST‑33Q will add the
to scroll to the user defined
� Select the
and use the Up
to scroll to the frequency that
as
Advertisement
Table of Contents
