QSC Q-SYS PAge Station Quick Start Manual

Page Station Quick Start Guide
Mounting the Hand-held Microphone Models
NOTE: The product shall be installed in accordance with the applicable local
code requirements.
Q‑Sys Page Stations are designed to be mounted on a wall or podium with an appropriate cutout and
cavity to allow all cables and power sources to connect to the Page Station rear panel with adequate
stress relief. The included Mounting Bracket is designed to mate with a standard triple‑gang U.S.
electrical box, but can be mounted directly to the wall.
1. Remove the Mounting Bracket from the Page Station. It is secured by one screw on the front edge of
Figure
the Page Station. Refer to
Refer to Figure 1.
2. Place the Microphone Strain‑relief Clamp
3. Plug the RJ‑45 plug (3) into the receptacle
(5)
4. Install screw through the clamp and into the Page Station to secure the Mic cable.
5. Route all Page Station wiring and connectors through the center of the Mounting Bracket.
6. Use four tripple‑gang screws (included)
triple‑gang electrical box if you are using one.
7. Use six screws (not included)
shall be appropriate for the surface to which the Page Station is mounted.
IMNOOT OE: The six screws, securing the Mounting Bracket to the wall, are required
even when using the triple‑gang electrical box.
8. Connect all Page Station wiring to the proper connectors on the Page Station. Refer to
Configuration and Setup" on page
Figure 3.
Refer to
9. Tilt the top of the Page Station back and install the Page Station onto the
Mounting Plate by aligning the two tabs on the Page Station with the two slots
on the Mounting Plate.
10. With the Page Station still tilted, carefully bundle the wiring back into the wall
(or triple‑gang electrical box).
11. Push the bottom of the Page Station to the wall.
12. Install and tighten the screw
Bracket up into the Page Station.
NOTE: Use these installation instructions to mount the
Hand‑held Page Station models to other surfaces as well.
TD-000359-00-A
*TD-000359-00*
™
3-1. Set the screw aside for later use.
(1) over the Microphone cable (2).
(4) on the Page Station.
(Figure 2-1) to align and mount the Mounting Bracket to the
(Figure 2-2) to secure the Mounting Bracket to the wall. The six screws
2.
(1) (removed in step 1) through the Mounting
"Page Station
1
1
5
1
4
— Figure 1 —
1
2
— Figure 2 —
Mounting tabs
on back of
Page Station
— Figure 3 —
3
1
2