Advertisement
Quick Links
Installation
Instructions
This kit is required when using the Triple Bag
Collector #1693501 and Hitch & Tube Kit
#1693791 grass collection system.
Kit Contents:
Part No. Qty. Descrpition
1846169
1
Stallion Weight Mount Rack
1846174
1
Weight Retainer Rod
N/A
2
Hairpin Clip
N/A
2
Bolt, 3/8-16 x 2"
N/A
2
Nut, 3/8-16 Nylon Lock
WARNING
Before beginning any service work turn off the
PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
INSTALLATION
1. Park machine on a flat, level surface and engage the
parking brake.
2. Measure and mark the front main frame tubes to the
dimensions shown in Figure 1. (1-1/4" down from the
top of the tube, 3/4" in from the end of the tube.)
3. Using a 3/8" drill bit, drill one (1) hole in each of the
main frame tubes from the outside surface of the
tube.
4. Slide the weight mount rack into the main frame
tubes and align with the holes drilled through the
frame (see Figure 2). It may require you drive the
arms into the frame tubes using a wooden block and
hammer.
5. Finish drilling through the opposite wall of the frame
tubes using the weight rack as a guide.
6. Install the 3/8" bolts and nuts and fasten securely.
7. Install the weight plates supplied with the grass col-
lector on the weight mount rack (see Figure 3).
8. Install the weight retainer rod through the weight
mount rack and secure with the hairpin clips (see
Figure 3).
9. Reinstall the spark plug wires.
© Copyright 2000 Ferris Industries. All Rights Reserved.
Derby Stallion Weight Mount Kit
1-1/4"
Figure 1. Hole Location
Figure 2. Weight Rack Installation
Figure 3. Weight & Retainer Rod Installation
1
Part No. 1846198
For all Derby Stallion ZT2354 mowers
3/4"
TP 200-7014-01-SL-D
1846262
Rev. 3/2001
Advertisement
