Process To Connect The Network; Process Overview - Hitachi iPJ-AW250N Network Manual

1. Connection to the network

1.3 Process to connect the network

Before connecting your computer and projector via a network, make sure that the
LAN port is selected as the input source on the projector. (
User's Manual – Operating Guide) Otherwise a connection cannot be established.

1.3.1 Process overview

An overview of the process to connect your computer and the projector via a
network is shown below.
The "LiveViewer" allows you to skip some of the steps below to establish a
network connection quickly and easily.
q Selecting the network connection mode
- Wireless LAN
- Wired LAN
- My Connection
w Selecting the network connection method
- Enter PassCode
- Configure Manually
- Select From List
e Manual configuration
- Profile
- History
- Configure Network Settings Manually
r Configuring the network settings manually
t Confirming the connection to your destination
NOTE • Wireless LAN can be selected only when an access point to convert
wireless LAN to wired LAN exists between your computer and the projector.
• Up to 30 computers can be simultaneously connected to the projector through
a network.
8
Operating in the
If My Connection is
selected
If Enter PassCode or
Select From List is
selected
If Profile or History is
selected