Setting Up Your Remote Control - Haier HLH26ATBB Owner's Manual

Setting Up Your Remote Control

After it has been set up properly, your remote control can operate in six different modes:
TV, VCR, CABLE, DVD, SETBOX or AUDIO Pressing the corresponding button on the remote control
allows you to switch between these modes, and control whichever piece of equipment you choose.
Note
The remote control might not be compatible with all DVD Players, VCRs and Cable boxes.
SELECT
CH.LIST
FAV.LIST AUDIO LIST
PIP SWAP AUDIO SWAP POSITION
P.MODE
S.MODE
CC FREEZE
OK
VOL+ CH+
VOL- CH-
Q.VIEW
.
Setup the desired device code
1
Find one code number from code list according to device`s Brand and model.
(See P41-P43 of the remode codes)
2
Press SELECT button continuously to select desired device.
3
Press and hold OK button, then press SELECT button about 3 seconds, till LED is ON.
Release OK and SELECT buttons. LED flash with a speed of 2 times one second. It indicates
the remote controller to enters Setup Mode.
4
Using the number buttons on the remote controller, enter three digits of code number
in turn. The LED will flash once for each press.
5
If the code number is correct, LED will keep on for 3 seconds then flash with a speed of twice
per second. You may press OK or PLAY to test if it can control your device. If no, turn to procedure
step 4 to try another code number. If ok, you may press OK to exit Setup Mode, the code number
will be stored. LED is off. If the code number is incorrect, LED will flash with a speed of 4 times per
second for 3 seconds, then flash with a speed of 2 times per seconds. You may turn to step 4 to try
another code number.
6
During Setup mode, press the other keys than digit keys(0-9) or no any key is pressed,
it will exit Setup Mode or with LED off.
Search Mode (Manual Search)
1
Turn on the desired device. If the device is VCR or DVD, etc, you should insert tape or disc into
the device.
2
Press SELECT button continuously to select desired device.
3
Press and hold OK, then press SELECT about 3 seconds till LED is O N(aim it at the remote
control sensor on the device). Release the the two buttons. LED flashes with a speed of twice per
second, which indicates the remote controller enters Setup Mode.
4
Press and release CH+/- button, it will send POWER IR signal of next or previous code number.
LED flashes.
5
During searching, if the device switch off, it indicates the code is searched successfully, Press
OK button to confirm.
6
During manual searching mode, press the other keys except digit keys(0-9) or no any key is
pressed in 30 seconds , it will exit Setup mode.
Search Mode(Auto Search)
1
Turn on the device. If the device is VCR or DVD, etc, you should insert tape or disc
into the device.
2
Press SELECT button continuously to select desired device.
3
Press and hold OK button, then press SELECT button about 3 seconds till LED is ON
( aim it at the remote control sensor on the device .
4
Press MUTE button to enter Auto Search Mode.
5
During searching, if the device switch off, it indicates the code is searched successfully, Press
OK button to confirm.
6
During Auto Search Mode, Press any key except OK button, it will exit Auto Search
Mode. LED is off.
)
Operation
Owner s Manual 39