Indoor unit 3.Installation of the Indoor Unit Drawing of pipe Rear piping Draw pipes and the drain hose, then fasten them with the adhesive tape Left Left-rear piping In case of left side piping, cut away, with a nipper, the lid for left piping. In case of left-rear piping, bend the pipes according to the piping direction to the mark of hole for left-rear piping which is marked on heat insulation materials.
Outdoor unit 5.Purging Method:To use vacuum pump Liquid Side Gas Side 6.35mm(1/4") 9.52mm(3/8") 12.7mm(1/2") 3-way valve 2-way valve Detach the service port's cap of 3-way valve, the valve rod's cap for 2-way valve and 3-way's, connect Gaugemanifold(for R410A) the service port into the projection of charge hose Anti countercurrent joint (low) for gaugemanifold.
Page 8
1.Power Source Installation The power source must be exclusively used for air conditioner. (Over I0A) In the case of installing an air conditioner in a moist place, please install an earth leakage breaker. For installation in other places, use a circuit breaker as far as possible. 2.Cutting and Flaring Work of Piping Pipe cutting is carried out with a pipe cutter and burs must be removed.
Unité intérieure 3. INSTALLATION DE L'UNITÉ INTÉRIEURE Sortie tuyauteries Sortie arrière • Faire passer les tuyaux et l'évacuation des condensats, puis les fixer avec du ruban adhésif. Sortie gauche et gauche-arrière • En cas de sortie des tuyauteries à gauche de l'unité intérieure, à l'aide d'un outil ouvrir le trou pré-découpé pour la sortie à gauche.
Unité extérieure • Si le câble d'alimentation est endommagé, le faire remplacer par le SAV ou par un professionnel qualifié. • Si le fusible sur la carte électronique saute, le remplacer par un de type T.3.15A/250V. • Le câblage doit être conforme à la réglementation et aux normes locales. •...
Unité extérieure TIRAGE AU VIDE Côté gaz Côté liquide 1. Retirer l'écrou qui protège l'ouverture de la vanne 3 voies sur l'u- vanne 3 voies vanne 2 voies nité extérieure. Retirer les écrous des vannes 3 voies et 2 voies. Puis raccorder le tuyau de basse pression du manomètre à...