Installation Options - QSC K12 YOKE User Manual

Attaching the Yoke to the Loudspeaker: Horizontal Mounting
The yoke bracket is designed to attach to the rigging points on the loudspeaker for either horizontal or vertical suspension.
1. Attach the yoke spacers using the included M5 screws in the locations shown in
shown is oriented toward the rear (amplifier) side of the enclosure.
2. Join the three parts of the yoke mount together with the provided hardware
3. Attach the yoke to the spacers using the M8 Hex Head Bolts included with the bracket. Note the hardware order
washers are to be installed between the bolt and the outside bracket surface. The lock washer is the outermost washer, located directly under the
head of each bolt.
4. Tighten the bolts snugly, just to the point where the yoke is held in place but able to rotate. Set desired tilt and tighten the two M8 bolts to secure
the loudspeaker in place.
– Figure 1 –
Attaching the Yoke to the Loudspeaker: Vertical Mounting
1. To attach the bracket to the loudspeaker enclosure for vertical mounting, locate the rubber inserts which protect the enclosure's threads. Remove
the rubber inserts.
2. Attach the yoke spacers using the included M5 screws in the locations shown in
shown is oriented toward the rear (amplifier) side of the enclosure.
3. Join the two halves of the yoke mount together with the provided hardware
the assembly, but is not required.
4. Attach the yoke to the spacers using the M8 Hex Head Bolts included with the bracket. Note the hardware order
washers are to be installed between the bolt and the outside bracket surface. The lock washer is the outermost washer, located directly under the
head of each bolt.
5. Tighten the bolts snugly, just to the point where the yoke is held in place but able to rotate. Set desired tilt and tighten the two M8 bolts to secure
the loudspeaker in place.
– Figure 4–

Installation Options

The yoke bracket can be used to support the K12 in several ways.
Yoke above or below loudspeaker enclosure
enclosure using the outermost set of mounting holes in the bracket's arms.
Do nothing
— Keep in mind, if you do not know what you are doing, don't mount this loudspeaker to anything, including the yoke bracket.
Consult professional assistance if unsure about any loudspeaker mounting or suspension topic or procedure.
(Figure
(Figure 2).
– Figure 2 –
(Figure
(Figure 5). The center extension part of the yoke can be included in
– Figure 5 –
— If using the yoke bracket positioned above or below the enclosure, attach to the
1). Ensure that the side of the spacer with the text "REAR"
(Figure
4). Ensure that the side of the spacer with the text "REAR"
(Figure
3). The steel flat and lock
– Figure 3 –
6). The steel flat and lock
– Figure 6 –