Fujitsu Inverter Halcyon ASU9R2 Operating Manual page 3

Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3 Indicator Lamps (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
G
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 12 Auto Restart).
7 SUPER QUIET Indicator Lamp (green)
8 SWING Indicator Lamp (orange)
9 Intake Grille (Fig. 4)
0 Air Filter (left)
A Air Flow Direction Louver
B Right-Left Louver
(behind Air Flow Direction Louver)
C Drain Hose
D Air Filter (right)
Fig. 5 Outdoor Unit
E Intake Port
F Outlet Port
G Pipe Unit
G Refer to the folded out page on the cover.
Fig. 6 Remote Control Unit
H MASTER CONTROL button
I SET TEMP. / SET TIME buttons (+/-)
J Signal Transmitter
K TIMER button
L FAN CONTROL button
M START/STOP button
N SLEEP button
O SET button
P SWING button
Q ACL button
R TIME ADJUST button
Rear side (Fig. 7)
S TEST RUN
G
Touch the two metal contacts with a
metallic object to send the signal to
perform a test run.
G Perform a test run only when installing the
air conditioner. If the signal to perform a
test run is received during normal
operation, the air conditioner's thermostat
will malfunction.
G If the signal to perform a test run is re-
ceived during normal operation, the unit
will switch to the test operation mode and
the indoor unit's OPERATION and TIMER
indicator lamps will flash simultaneously.
G
To stop the test operation mode, press the
START/STOP button to stop the air
conditioner.
T Remote Control Unit Display (Fig. 8)
U Transmit Indicator
V Clock Display
W Operating Mode Display
X T imer Mode Display
Y Fan Speed Display
Z Temperature Set Display
[ T imer Set Indicator
\ Temperature Set Indicator
En-2