Off Season Storage - Yard-Man 109 Operator's Manual

20" mulching push lawn mower
Table of Contents

Advertisement

Cutting Deck
The underside of the mower deck should be
cleaned after each use to prevent a build-up of
grass clippings, leaves, dirt or other matter. If this
debris is allowed to accumulate, it will invite rust
and corrosion, and may prevent proper mulching.
The deck may be cleaned by tilting the mower and
scraping clean with a suitable tool (make certain the
spark plug wire is disconnected).
NOTE:
We do not recommend
the use of pressure
washers or garden hose to clean your unit. They may
cause damage to bearings or the engine. The use of
water will shorten fife and reduce serviceability.
Engine
Refer to the engine manual for all engine
maintenance instructions.
Maintain engine oil as instructed in the engine
manual.
Service air cleaner every 25 hours of operation
under normal conditions. Clean every few hours
under extremely dusty conditions. Poor engine
performance and flooding usually indicates that the
air cleaner should be serviced. To service the air
cleaner, refer to the engine manual.
The spark plug should be cleaned and the gap
reset once a season. Spark plug replacement is
recommended at the start of each mowing season;
check engine manual for correct plug type and gap
specifications.
Clean engine regularly with a cloth or brush. Keep
the cooling system (blower housing area) cleaned
to permit proper air circulation which is essential to
engine performance and life. Make sure to remove
all grass, dirt and combustible debris from muffler
area.
SECTION 8: OFF-SEASON S TORAGE
The following steps should be taken to prepare lawn
mower for storage.
Clean and lubricate mower thoroughly as described
in the lubrication instructions.
NOTE:
We do not recommend
the use of pressure
washers
or garden
hose to clean your
unit. They may
cause
damage
to bearings
or the engine.
The use of
water
will
result
in
shortened
life
and
reduce
serviceability.
Refer to engine manual for correct engine storage
instructions.
Coat mower's cutting blade with chassis grease to
prevent rusting.
Store mower in a dry, clean area. Do not store next
to corrosive materials, such as fertilizer.
NOTE:
When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rust-proof the equipment.
Using a light oil or
silicone, coat the lawn mower, especially cables and all
moving parts, before storing it for the off-season.
12

Advertisement

Table of Contents
loading

Table of Contents