Table of Contents
Advertisement
NOTE: Standbehind
themower a sil you
weregoing tooperate
it.Yourright h andcor-
responds totheright
i sideofthemower; your
lefthand corresponds
totheleftsideofthe
mower.
NOTE: "(our mower
isshipped withthe
handle inthehigher
height p ositic n ,
NOTE: E ach endof
i thelower handle must
beplaced inthesame
i relative position.
iMPORTANT
I
This unit is shipped
i without gasoline or
i oil inthe engine. Fill
!i up gasoline and oil
as instructed inthe
i accompanying engine
manual BEFORE
operating your mower.
Step 1
HardwarePack
Wing Nuts (2)
CarriageBolts (2)
1. Removeanypackingmaterialwhich may be between
upperand lowerhandles.
a. Pull up and backon upperhandleas shownin
Step 1.Makecertainthe lowerhandleis seated
securelyintothe handle mountingbrackets.
b. Tightenhandknobs securingupperhandleto
lowerhandle.Make surethat eachcarriagebolt is
seatedproperlyin the handle.
2. Locatehairpinclip in one holeon the weldpin on each
sideof lowerhandle.
.
a. Removehairpinclipfrom this hole.Usinga pair of
pliers,insert hairpinclip intothe other holeon the
weldpin. Repeaton otherside.
b. Inserta carriagebolt fromthe hardwarepack into
the upperhole on the handle mountingbracket.
Securewith one plasticwing nut,also included
in the hardwarepack.Repeaton other sidewith
remainingitemsfrom hardwarepack.
The ropeguide is attachedto the right sideof the
upperhandle.Loosenthe wingnut which securesthe
rope guide.
a. Holdblade controlhandleagainstupper handle.
b. Pull starterropeout of the engine.Releaseblade
controlhandle.
c. Slip starterrope into ropeguide.Tightenwingnut.
4. Insertpost on cable ties intoholes providedon the
lowerhandle.Pull cabletie tight and trim excess.
Step 2
Step
3
Step 4
6
Advertisement
Table of Contents
