Table of Contents
Advertisement
To Remove:
1. Push in the edge of coil element toward the receptacle. Then
lift it enough to clear the burner bowl.
3. Lift out the burner bowl.
To Replace:
1. Line up openings in the burner bowl with the coil element
receptacle.
2. Pull the coil element straight away from the receptacle.
\
2. Holding the coil element as level as possible, slowly push the
coil element terminal into the receptacle.
3. When the terminal is pushed into the receptacle as far as it
will go, push down the edge of the coil element opposite the
receptacle.
ELECTRONICOVENCONTROL
\
\
\
C
D
TIMER
/
CLOCK
_
/
/
/
K
J
I
H
G
F
E
A. Bake
E. Cancel
I. Clean (on some models)
B. Clock/timer
display
F. Keep warm
J. Cook & hold
C. More (+)/less (-) buttons
G. Clock
K. Broil
D. Timer
H. Delay
When power is supplied to the range or after a power
interruption, the last clock time before power was interrupted will
flash.
Bake or Lock may flash rapidly in the display to alert you if there
is an error or problem. Press CANCEL and reset clock if needed.
When the oven is in use, the display shows the temperature and
oven setting.
When the oven is not in use, the display shows the time of day.
When using the TIMER, for settings of 1 to 59 minutes, the
display will count down in minutes. The last minute will count
down in seconds. For settings of 1 hour or more, the display will
count down hours and minutes.
The CANCEL button stops any function except the Clock, Timer
and Control Lock. When you press the CANCEL button, the
display will show the time of day, or the time remaining if the
TIMER is being used.
The clock can be set to display time in a 12-hour or 24-hour
format. The clock is set at the factory for the 12-hour format.
To recall the time of day when another time function is showing,
press the Clock pad.
Clock time cannot be changed when the oven has been
programmed
for Delay Cook, Clean, or Cook & Hold.
To Change the Clock to 24-hour
Format:
1. Press and hold CANCEL and DELAY for 3 seconds.
2. Press the "up" or "down"' arrow pad to select 24 hour.
To Set:
1. Press CLOCK. The colon will flash in the display.
2. Press the "up" or "down"' arrow pads to set the time of day.
3. Press CLOCK or wait 4 seconds. The colon stops flashing.
To Cancel the Clock
Display:
If you do not want the time of day to display:
Press and hold CANCEL and CLOCK for 3 seconds, the time of
day will disappear from the display.
Advertisement
Table of Contents
