Electronic Oven Controls; Display; Start; Off/Cancel - Whirlpool SF367LXSQ0 Use & Care Manual

ELEC ONIC OVENCONTROLS
Style 1 - Electronic Oven Controls (on some models)
A B C D E F
o0
............ii
NM LK J / H G
The Start pad begins any oven function. If the Start pad is not
pressed within 5 seconds after pressing a function pad, the
"START?" indicator light will flash as a reminder. On some
models, "START?" will appear on the display.
If the Start is not pressed within 5 minutes after pressing a
function pad, the oven display will return to the time of day mode
and the programmed function will be canceled.
The Off/Cancel pad stops any function except the Clock, Timer
and Control Lock.
A. Auto clean H. Hour/minute
B. Start time L Temperature
C. Oven display J. Cooking functions
D. Clock K. Cook time
E. Timer set/off L. Control lockout
E Start M. Night Iight/Cooktop lockout
G. Off/Cancel N. Oven light
Style 2 - Electronic Oven Controls (on some models)
A B C D E
On some models, this is a 12-hour clock that shows a.m. and
p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Depending on your model, press the HR or MIN or
TEMP/HOUR "up" or "down" arrow pads to set the time of
day, including a.m. or p.m.
3. Press CLOCK or START.
)
OVEN CLOCK CookTme
_ake 8r0il Clean Warm On
5tart?
TEMP/HOUR
G
A. Oven light E Temp/Time
B. Clock G. Cooking functions
C. Display H. Control lockout
D. Start L Auto Clean
E. Cancel/Off J. Timer
When power is first supplied to the appliance, a flashing time will
appear on the display. Press OFF/CANCEL to clear flashing time
from the display.
If flashing time appears, a power failure has occurred. Press
OFF/CANCEL and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
Tones are audible signals, indicating the following:
One tone
• Valid pad press
• Oven is preheated (long tone)
• Function has been entered
• Reminder, repeating each minute after the end-of-cycle tones
Three tones
• Invalid pad press
Four tones
• End of cycle
Reminder Tones: Reminder tones may be turned off. On some
models, press and hold STOP TIME for 5 seconds. "rEP OFF" or
"off" will appear in the display. Repeat to turn reminder tones
back on, and "rEP on" or "on" will appear in the display.
All Tones: All of the above tones are preset on. All except the
end-of-cycle tones can be turned off.
To Turn Off/On (on some models): Press and hold START TIME
for 5 seconds. A tone will sound, and "Snd OFF" will appear on
the display. Repeat to turn tones on, and "Snd on" will appear on
the display.
On some models, only the loudness of the tones can be adjusted.
On other models, the tones cannot be adjusted or turned off.
Tone Pitch: The pitch is preset at high, but can be changed to
low. On some models, only the loudness of the tones can be
adjusted. On other models, the tones cannot be adjusted or
turned off.
To Change (on some models): Press and hold BAKE for
5 seconds. A tone will sound, and "Snd LO" will appear on the
display. Repeat to change, and "Snd Hi" will appear on display.