Ceramic Glass; Dual Watt Element; Accusim M Er®Feature - Whirlpool GJC3034LT02 Use & Care Manual

The surface cooking area will glow red when an element is on. It
will cycle on and off, at all settings, to maintain the selected heat
level.
It is normal for the surface of white ceramic glass to appear to
change color when surface cooking areas are hot. As the glass
cools, it will return to its original color.
Wiping off the cooktop before and after each use will help keep it
free from stains and provide the most even heating. For more
information, see "General Cleaning" section.
• Do not store jars or cans above the cooktop. Dropping a
heavy or hard object on the cooktop could crack it.
Do not leave a hot lid on the cooktop. As the cooktop cools,
air can become trapped between the lid and the cooktop,
and the ceramic glass could break when the lid is removed.
Clean up sugary spills and soils as soon as hot surface
indicator light goes off. If spills or soils are not wiped up while
warm, surface pitting can occur.
Do not slide cookware or bakeware across the cooktop.
Aluminum or copper bottoms and rough finishes on
cookware or bakeware could leave scratches or marks on the
cooktop.
Do not cook popcorn in prepackaged aluminum containers
on the cooktop. It could leave aluminum marks that cannot
be removed completely.
Do not allow objects that could melt, such as plastic or
aluminum foil, to touch any part of the entire cooktop.
Do not use the cooktop as a cutting board.
Use cookware about the same size as the surface cooking
area. Cookware should not extend more than 1 in. (2.5 cm)
outside the area.
I
\ / 3
1. Surface Cooking Area
2. Cookware/Canner
3. 1 in. (2.5 cm) Maximum Overhang
Use flat-bottomed cookware for best heat conduction and
energy efficiency. Cookware with rounded, warped, ribbed or
dented bottoms could cause uneven heating and poor
cooking results.
Determine flatness by placing the straight edge of a ruler
across the bottom of the cookware. While rotating the ruler,
no space or light should be visible between it and the
cookware.
Cookware designed with slightly indented bottoms or small
expansion channels can be used.
Make sure the bottoms of pots and pans are clean and dry
before using them. Residue and water can leave deposits
when heated.
•
Do not cook foods directly on the cooktop.
Hot Surface Indicator Light (under ceramic glass)
The hot surface indicator light will glow as long as any surface
cooking area is too hot to touch, even after the surface cooking
area(s) is (are) turned off.
1. Single Size
2. Dual Size
The Dual Watt Element is located on the left front surface cooking
area. Use single size for average-size cookware and average
quantities of food. Use dual size for home canning, large
diameter cookware and large quantities of food.
DUAL ZONE
O O OFF_
00o
To Use SINGLE Size:
1. Push in and turn knob counterclockwise from the OFF
position to the SINGLE zone anywhere between HI and LO.
2. Push in and turn knob to OFF when finished.
To Use DUAL Size:
1. Push in and turn knob clockwise from the OFF position to the
DUAL zone anywhere between HI and LO.
2. Push in and turn knob to OFF when finished.
®
The ACCUSIMMER feature setting is an adjustable heat setting
for more precise simmering, It is the left front surface cooking
area or element. The indicator light will glow when the
ACCUSIMMER ® feature is in use.
The ACCUSIMMER ®control knob has two settings: SIMMER and
NORMAL BURNER. When the control is set on NORMAL
BURNER, the left front surface cooking area or element will
function as a single or dual element (on some models).