Display; Clock - Whirlpool RF341BXKW0 Use & Care Manual

IMPORTANT: Never leave e mpty cookware onahotsurface
cooking a rea, e lement orsurface b urner.
Ideal cookware should have aflatbottom, straight sides, a well-
fitting lidand thematerial should b eofmedium-to-heavy
thickness.
Rough f inishes may scratch t hecooktop. Aluminum andcopper
may beused asacore orbase incookware. However, when used
asabase itcanleave p ermanent marks o nthecooktop o rgrates.
Cookware material isafactor i nhow quickly a ndevenly h eat i s
transferred, which affects c ooking r esults. Anon-stick finish has
thesame characteristics asitsbase material. For e xample,
aluminum c ookware witha non-stick finish will t ake onthe
properties ofaluminum.
Use thefollowing c hart a saguide forcookware material
characteristics.
COOKWARE CHARACTERISTICS
Aluminum • Heats q uickly a nd evenly.
• Suitable foralltypes ofcooking.
• Medium orheavy t hickness isbest f or
most c ooking t asks.
Cast iron
• Heats slowly and evenly.
• Good for browning and frying.
• Maintains heat for slow cooking.
• Follow manufacturer's instructions.
• Heats slowly, but unevenly.
• Ideal results on low to medium heat
settings.
Ceramic or
Ceramic glass
Copper • Heats very quickly and evenly.
Earthenware • Follow manufacturer's instructions.
• Use on low heat settings.
Porcelain • See stainless steel or cast iron.
enamel-on-
steel or cast
iron
Stainless steel • Heats quickly, but unevenly.
• A core or base of aluminum or copper
on stainless steel provides even
heating.
/
TIMER
1. Clock
2. Display
3. Increase
4. Decrease
5. Timer
When power is first supplied to the appliance, everything on the
display will light up for 5 seconds. Then "PF" will appear on the
display,
Any other time "PF" appears, a power failure occurred, Reset the
clock. See "Clock" section.
When the oven is not in use, the display will show the time of day.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
The colon will flash during Clock programming.
2. Press the "up" or "down" arrow pads to set the time of day.
The time can be changed in either small or 10 minute
increments by pressing a pad briefly or by pressing and
holding a pad.
3. Press CLOCK. The colon will stop flashing when the Clock is
active.