Troubleshooting - Weed Eater BV1850 Instruction Manual

Hide thumbs Also See for BV1850:
Table of Contents

Advertisement

Available languages

Available languages

SEASONAL
STORAGE
Prepare unit for storage at end of season or if
it will not be used for 30 days or more.
If your unit is to be stored for a period of time:
• Clean the entire unit before lengthy
stor-
age.
• Store in a clean dry area.
• Lightly oil external metal surfaces.
FUEL SYSTEM
Under FUELING
ENGINE
in the OPERA-
TION section of this manual, see message la-
beled IMPORTANT
regarding the use of ga-
sohol in your engine.
Fuel stabilizer is an acceptable altemafive in
minimizing the formation of fuel gum deposits
dudng storage. Add stabilizer to gasoline in fuel
tank or fuel storage container. Follow the mix
instructions found on stabilizer container. Run
engine at least 5 minutes after adding stabilizer.
ENGINE
• Remove spark plug and pour 1 teaspoon of
40:1, 2-cycle engine oil (air cooled) through
the spark
plug opening.
Slowly
pull the
starter rope 8 to 10 times to distribute
oil.
• Replace spark plug with new one of recom-
mended type and heat range.
• Clean air filter.
• Check entire unit for loose screws, nuts,
and bolts. Replace any damaged,
broken,
or worn parts.
• At the beginning
of the next season,
use
only fresh fuel having the proper gasoline to
oil ratio.
OTHER
• Do not store gasoline
from one season to
another.
• Replace your gasoline can if it starts to rust.
TROUBLESHOOTING
TABLE
WARNING:
Always stop unit and disconnect spark plug before performing any of the
recommended remedies below other than remedies that require operation of the unit.
TROUBLE
CAUSE
REMEDY
Engine will not
1. Engine flooded.
1. See "Starting a Flooded Engine"
start,
in Operation section.
2. Fuel tank empty.
2. Fill tank with correct fuel mixture.
3. Spark plug not firing.
3. Install new spark plug.
4. Fuel not reaching
4. Check for dirty fuel filter; replace.
carburetor.
Check for kinked or split fuel line;
repair or replace.
5. Compression
low.
5. Contact an authorized service dealer.
Engine will not
1. Fuel not reaching
1. Check for dirty fuel filter; replace.
idle properly,
carburetor.
Check for kinked or split fuel line;
repair or replace.
2. Carburetor
requires
2. Contact an authorized service dealer.
adjustment.
3. Crankshaft seals worn.
4. Compression
low.
1. Air filter dirty.
2. Fuel not reaching
carburetor.
Engine will not
accelerate,
lacks power, or
dies under a
load.
Engine smokes
excessively.
3. Spark plug fouled.
4. Carburetor
requires
adjustment.
5. Carbon build up.
6. Compression
low.
I. Choke partially on.
2. Fuel mixture incorrect.
3. Air filter dirty.
4. Carburetor
requires
adjustment.
3. Contact an authorized service dealer
4. Contact an authorized service dealer.
1. Clean or replace air filter.
2. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
3. Clean or replace spark plug
and re-gap.
4. Contact an authorized service dealer.
5. Contact an authorized service dealer.
6. Contact an authorized service dealer.
I. Adjust choke.
2. Empty fuel tank and refill with
correct fuel mixture.
3. Clean or replace air filter.
4. Contact an authorized service dealer.
Engine runs hot.
1. Fuel mixture incorrect.
1. See "Fueling
Engine" in Operation
section.
2. Spark plug incorrect.
2. Replace with correct spark plug.
3. Carburetor
requires
3. Contact an authorized service dealer.
adjustment.
4. Carbon build up.
4. Contact an authorized service dealer.
-9-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bv2000Bv200Bv1650Bv1800

Table of Contents