The Mib Poller Detail Report - Extreme Networks EPICenter Guide Manual

Collection Name The name of the collection
Polling Interval The polling interval, in seconds
Save Polled Data Whether the polled data is being saved in the database (Yes or No)
Scope The devices on which polling for this data is being conducted
Status The status of the collection (running or stopped)
Startup State Whether the poll should be started automatically when it is loaded (running) or should be
left in the stopped state
Poll Saving Limit The lower boundary of the number of poll results that will be saved in the database. This
value is calculated by taking the maximum number of saved polls multiplied by the delete
percentage. The actual number of poll data sets in the database at any given time will be
somewhere between this value and the maximum poll saving limit.
Poll Limit A limit on the number of polls that should be performed. Currently this is always None, the
number of polling cycles cannot be limited at this time.
The two tables below show the scalar and tabular MIB variables (OIDs) for which polling will be done.
Each variable is identified by its OID and the data label that was provided in the xml file.

The MIB Poller Detail Report

The Poller Detail report simply shows the status of the collection for each device in the collection scope.
Figure 61: MIB Collection Detail Report
EPICenter Concepts and Solutions Guide
Using the MIB Poller Tools
141