Product Overview; Operation; Controls - Exmark LAZER Z ADVANTAGE SERIES Operator's Manual

Operation

Product Overview

Figure 4
1. Motion Control Lever
2. Parking Brake Lever
3. Height-of-Cut Lever
4. Fuel Cap (Both Sides)

5. Controls

6. Seat Belt
7. Roll Bar
Operation
Note: Determine the left and right sides of the
machine from the normal operating position.
Controls
Motion Control Levers
The motion control levers located on each side of the
console control the forward and reverse motion of
the machine. The levers control the flow of hydraulic
oil from the hydrostatic pump to the drive wheel
motor for each side.
Moving the levers forward or backward turns the
wheel on the same side forward or in reverse. Wheel
speed is proportional to the amount the lever is
moved.
Moving the levers outward from the center position
into the T-slot locks them in the neutral position
(Figure 6).
Choke Control
Located at lower center on the console (right side of
ignition switch).
Choke is used to aid in starting a cold engine. The
choke control is pulled out to put the choke in the
"ON" position and pushed in to put the choke
control in the "OFF" position. DO NOT run a
warm engine with choke in the "ON" position.
Throttle Control
Located on console just right of center.
The throttle is used to control engine speed. Moving
the throttle lever forward will increase engine speed
and moving the throttle lever to the rear will decrease
engine speed. Moving the throttle forward into the
detent is full throttle.
Brake Lever
Located on left side of unit, just to the front of the
console.
The brake lever engages a parking brake on the drive
wheels.
Pull the lever up and rearward to engage the brake.
18