Hot Lamination; Cold Lamination - Fellowes SPL 125 Owner's Manual

S e t- u p
Using the illustration on the inside of the manual cover as a reference, attach the support tray
to the back of the machine with the two screws included in the package
O p e r a t i o n
To begin laminating, plug in the machine and press the power button
, then press start

Hot Lamination

Using the guidelines
• Set temperature by pressing
The digital temperature display
show the last temperature used. Press plus
want. Note: Because even standard paper may vary in weight and some inks are heat sensitive,
you may have to use a somewhat higher or lower temperature – roughly 5° more or less – to
get optimum results.
• Set speed by pressing
The digital speed display
speed used. Press plus
Then press forward
laminator will warm up without the rollers in motion, this ensures
that the heat will be evenly distributed. As soon as the selected
temperature has been reached, the green ready light
on. Allowing for a free margin of at least 3 mm (1/8 inch), on the
unsealed edges, insert the sealed edge of the pouch or mounting
board into the entry
If you see the material is not going in straight and might get dam-
aged, use the reverse mode: Press stop
reverse until you have backed the material out of the entry
completely. Realign and press forward
Remove your material from the support tray after it has cleared the exit
with the job, but plan to use the laminator again soon, press start
m o d e. If you forget, it will switch itself into this mode after one hour of inactivity. Press start
again to resume work, or press the power button

Cold Lamination

Using the same t e m p e r a t u r e and speed selection procedure as with hot lamination, lower the
temperature until the digital display is blank. The cold mode light
confirm the change in mode. Then select a speed of 5 or 6, depending on the contents and
pouch thickness.
Press forward to start the rollers turning. (If the laminator is hot, you can accelerate the
cooling process by passing through the cleaning sheet included in the package and/or turning
up the roller speed to 7, 8 or 9.) When the green ready light
to 5 or 6 if necessary, then:
4
, which will cause the orange standby light
printed on the top of the machine:
, which will cause the temperature light
A
will show 110° C if this is the first use, but otherwise will
a second time, which will cause the speed light
B
will show "4" if this is the first use, but otherwise will show the last
or minus until you see the speed you want.
to start the rollers turning. Although the
, as shown at the right.
, then press and hold
to begin again.
D to go on.
or minus until you see the temperature you
C
will go
to put it into the s t a n d b y
to turn off the machine.
will go on at this point to
C
goes on, turn the speed back
. On the control panel
to go on.
to go on.
. If you are finished