Toro TimeCutter Z380 Operator's Manual page 38

Troubleshooting
Problem
The engine overheats.
The starter does not crank
Possible Cause
1. The engine load is
excessive.
.
3.
.
The oil level in the
crankcase is low.
The cooling fins and
air passages under the
engine blower housing
are plugged.
The air cleaner is dirty.
5. Dirt, water, or stale fuel
is in fuel system.
1. The blade control switch
is engaged.
2. The motion control
levers are not in the
Corrective Action
1. Reduce ground speed.
2. Add oil to the crankcase.
.
Remove the obstruction
from the cooling fins and
air passages.
.
5.
Clean or replace the air
cleaner element.
Contact an Authorized
Service Dealer
1. Move the blade control
switch to Disengaged.
2. Move the motion control
levers to the brake
brake position.
3. The operator is not
seated.
4. The battery is dead.
5. The electrical
connections are
corroded or loose.
6. A fuse is blown.
7. A relay or switch is
damaged.
position.
3. Sit on the seat.
4. Charge the battery.
5. Check the electrical
connections for good
contact.
6. Replace the fuse.
7. Contact an Authorized
Service Dealer.
38