Adjusting The Speaker Levels And Balance (Test Tone) - Sony HT-7000DH Operating Instructions Manual

8: Adjusting the speaker
levelsand balance
(TEST TONE)
You can adjust the speaker levels and balance
while listening to the test tone from your
listening position.
Tip
Tile receiver employs a test tone with a frequency
centered at 800 Hz.
2-!
MASTER
VOL +/-
Adjust the speaker levels and
balance using the LEVEL menu
so that the level of the test tone
sounds the same from each
speaker.
For details, see "Adjusting tile level
(LEVEL menu)" (page 42).
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +_. You can also
use MASTER VOLUME on tile receiver.
• The adjusted value are shown on tile display
during ac[jnstment.
Repeat steps 1 to 5 to select
"T. TONE N".
Tile test tone tnrns oft'.
Note
The test tone does not work when MULTI CH IN is
selected.
4
! Press AMP MENU.
"'l-LEVEL" appears on tile display.
2
Press the control button or
control button * to enter the
menu.
3
4
5
Press control button _/4,
repeatedly to select "T. TONE".
Press the control button or
control button, to enter the
parameter.
Press control button tit
repeatedly to select "T. TONE
y",
Tile test tone is
output
from each speaker
in sequence as follows:
Front left -+ Center -+ Front right -+
Surround right -+ Surround left -+
Stlb woofer
34us