Receiver; Connecting Two Vcrs For Editing; A/V Receiver; Two Vcrs For Editing - Sony Trinitron KV-32V68 Operating Instructions Manual
Hide thumbs
Also See for Trinitron KV-32V68:
- Operating instructions manual (45 pages) ,
- Supplementary manual (1 page) ,
- Service manual (80 pages)
Table of Contents
Advertisement
Connecting
and Installing
the TV (continued)
Connecting
an A/V receiver
1 Using A/V
cables, connect TV OUT on your
TV to TV IN on your A/V receiver.
2
Using a single video connector,
connect
MONITOR
OUT on your A/V receiver to
VIDEO 1 IN on your TV.
Note
•
When you are in a video mode (VIDEO 1, 2, or 3),
you will not be able to access the GUIDE Plus+
feature.
Connecting
two
VCRs for editing
MONITOR
OUT gives you the ability to use a
second VCR to record a program
being played
by the primary
VCR or to perform
tape editing
and dubbing.
1
Connect
the VCR intended
for playback
using
the setup instructions
on page 5 of this
manual.
2
Using A/V
connectors,
connect
AUDIO and
VIDEO IN on your VCR intended
for
recording
to MONITOR
AUDIO and VIDEO
OUT on your TV.
VIDEO (yellow)2j
I
VMC-10HG/30HG (not supplied)
(Rear of TV)
A/V outputs
I_l
A/V receiver
VIDEO (yellow) _
h
AUDIO-L (white) _
/V inputs
AUDIO-R (red)4_
/
VMC-810S/820S (not supplied)
You should not change video
inputs while editing
using
MONITOR
OUT.
l (Rear of TV)
VCR (for playback)
I
VMC-810S/820S (not supplied)
VCR (for recording)
iN
_VIDEO
(yellow)
_
AUDIO-L (white) -_1 V
AUDIO-R (red)
-_
I
VMC-810S/820S (not supplied)
8
Advertisement
Table of Contents
