Mower Deck Leveling - Simplicity 1725764 Operator's Manual

TroubieshootJflg, Adjustmflts, & Service
Figure 27. Orient Blades Side=to=Side
MOWER DECK LEVELING
Perform these adjustments on a flat level surface.
Note: Do not adjust the mower rift height rod (H, Figure
29) as it will effect the mower deck lift height,
SIDE-TO=SIDELEVELING
1. With the mower installed, place the rider on a
smooth, level surface such as a concrete floor. Turn
the front wheels so they are straight.
2. Check for bent blades and replace if necessary.
3. Place the mower cutting height pin in the 4th hole
from the bottom (C, Figure 29). Arrange the
outside mower blades so that they are pointing from
side-to-side (Figure 27).
4. Measure the distance between the outside tips of
each blade and the ground (Figures 27 & 28). If there
is more than 1/8" (3mm) difference between the
measurements on each side, proceed to step 5. If the
difference is 1/8" (3mm) or less, proceed to step 6.
5. Use the rear leveling rods (B, Figure 29) to adjust the
side-to-side leveling of the deck. Repeat step 4 if
necessary.
FRONT=TO-BACKLEVELING
6. Arrange the blades so they face front-to-back (Figure
30).
7. Measure the distance from the ground to the front tip
of the center blade, and from the ground to rear tips
of left-hand and right-hand blades (Figures 28 & 30).
The front tip of the center blade should be 1/4" (6mm)
higher than rear tips of left-hand and right-hand
blades. If not, proceed with steps 8 - 11.
8. Check the length of the hanging rods: the rear (D,
Figure 29) should be 15" (38,1cm) and is not adjust-
ed. The front rods (E) should be initially adjusted to
14-3/4" (37,5cm). To adjust the pitch of the mower
deck, adjust the front pitch rods only.
9. To lower the front of mower deck, loosen the set col-
lars (F, Figure 29) and slide towards the mower deck,
loosen the jam nuts (A) and adjust the clevises out.
Reverse this to raise the front of the mower. Be sure
to raise or lower both clevis the same amount.
Figure 28. Measure Blade Tips to Ground
A. Mower Deck C. Level Ground
B. Blade Tip
Figure 29. Mower Leveling
A. Front Leveling Jam Nuts
B. Rear Leveling Rods
C. 4th Cutting Height Hole
D. Rear Hanger Rods
E. Front Hanger Rods
F. Set Collars
G. Stabilizer
H. Mower Height Rod
Figure 30. Orient Blades Front-to=Back
10. Re-check the blade measurement then repeat steps
7-11 as necessary.
11. Reposition the deck stabilizers (G) against the jam
nuts (A) and push the set collars (F) up to meet the
stabilizer and tighten.
27