Snapper LT160H42IBV Safety Instructions & Operator's Manual page 64

Lawn tractor hydrostatic drive electric clutch series i
Hide thumbs Also See for LT160H42IBV:
Table of Contents

Advertisement

Section 4- ADJUSTMENT
& REPAIR
WARNING
DO NOT attempt
any adjustments,
maintenance
or
service with the engine
or blades
running.
STOP
blades.
STOP
engine.
Set
brake.
Remove
key.
Remove spark plug wire from spark plug and secure
wire away from spark plug. Engine and components
can be extremely hot. Avoid burns by allowing engine
and components
sufficient time to cool.
4.2.3.
MOWER DECK ADJUSTMENT
(LEVELNESS)
1. SIDE-To-SIDE (42" Decks)
j.
Reconnect sector plates, remove angle iron,
pipe, etc. and recheck side to side level. Adjust as
needed to result in blade tips being within 118"of the
same distance from the floor.
k. Proceed to check front to rear deck pitch.
SECTOR PLATES
!
"\
& WASHER
FIGURE 4.4
HAIR PIN
CLEVIS
WASHER
FIGURE 4.3
- TURN ECCENTRIC
AS REQUIRED
4.2.4.
MOWER DECK ADJUSTMENT
(LEVELNESS)
FRONT-To-REAR
(42" Decks)
1.
Remove hair pins and washers securing sector
plates to rear lift arms. See Figure 4.4.
2.
Move sector plate as required to raise or lower the
rear of deck.
NOTE" The deck should be set so that the rear of the deck
is 1/4" lower than the front.
3.
If the sector plates are in their lowest setting and
proper level cannot be obtained, adjust the front lift rod
as follows:
4.
Move deck lift lever to #5 position.
5.
Place a 2 x 4 wooden block on edge under front
center of deck.
6.
Place a 3 x 3 wooden block under rear center of
deck.
7.
Remove hair pins and washers securing sector
plates. Lower rear of deck onto 3 x 3 block.
8.
Remove hair pin and washer securing front lift cable
to front lift arm. See Figure 4.5.
LIFT CABLE
FRONT LIFT ROD
HANGER
FIGURE 4.5
9.
Remove front lift cable and rest front of deck onto
2 x 4 block.
10. Loosen jam nut on front lift cable. See Figure 4.5.
11. Rotate front lift cable until it can be reinstalled into
front lift arm without lifting deck.
12. Secure lift cable to lift arm with washer and hair pin.
Secure jam nut.
13.
Reinstall sector plates onto rear hanger brackets
and secure with washers and hair pins.
14.
Raise deck and remove wooden blocks.
15.
Repeat steps for front to rear level until levelness is
acquired.
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lt180h42ibv2

Table of Contents