Samsung HLN437W Instruction Manual page 3

_4
Safety Instructions
• Protecl the power cord. Power supply cords sbeu[d be routed so ;hal ;hey won't be walked on or
pinched by ob acts placed on or against ;hem Pay particular ot_enttan to cords at plugs, convenience
receptacles, and ;he potal where ;hey exil from ;he unit
• Unplug ;he TV from the wall outlet and disconnect the antenna or cable system during a lightning storm
or when left una_nded and unused for long periods of time This will prevenl damage te ;he unll from
lightning and power4ine surges.
• Avoid overhead power lines An ovlside antenna system should hal be placed in lbe vicinity of over-
head power lines or other electric ligh_ or power circuits, or where il can fall inlo such power lines or
circuits. When installing an outside antenna system, be exlremely carefu_ to keep from _ouching the
power lines or circuits Contacl wi;h such lines can be fatal
• Do hal overload ;he wall outlet or exlension cords Overloading can resuff in fire or electric shock
• Do hal insert any;hing ;hrough the openings in ;he unil, where ;hey can touch dangerous voltage points
or damage ports Never spill liquid of any kind on ;he TV
• Ground ouldoor antennas ff an outside anlenna or cable
_x_v_c_ ! EX_eL_ ° _
system iS connected te ;he _, be sure lhe antenna or cable _NN_ _ _%_ _
system iS grounded so as to provide some prolec_ion against _ _ "
voltage sur_s and built-up staffc charges Section 810 of the _!o,_,%_o_
National Electrical Code, ANSI/NFPA No 70_1984, pro.............
vides information aboul proper grounding of ;he mast and o_%'Z_
supporting structure, grounding of ;he tead-ln wire ta an ,N_ _,,o ,_
antenna discharge vni_, size of grounding conductors, .......
Iocalion of antenna discharge unit, connection to grounding _o_,g_,_¢0,_
electrodes, and requirements for ;he grounding electrode _ _'°_ °_ _ _'_'_
• Do hal attempt ta service ;he TV yourseff Refer all servicing to qualified service personne_ Unplug ;he
unit from the wall gullet and refer servicing to qualified service personnel when:
The power-supply cord or plug is damaged
Liquid has been spilled on the unil or ff obiects have fallen tate ;he uni_
The TV has been exposed to rain or water
The TV does not o rate normally b followin the operalin instrucltans
The TV has been 5Pr_pped or ;he ca_inel has _een damage_
The TV exhibits a distinct degradation in performance
When ;he LAMP[gULB ONLY} replacemenl is needed
• tf you make adjustments yourself, adjust only ;hose controls that are covered by the operallng instruc-
tions Adjus_tag other controls may result in damage and will often require extensive work by a qualified
technician to restore ;he TV to normal
• When reptacemenl parts are required, be sure ;he service technician uses repJacemenl parts specified
by the manufacturer or ;hose that have the same characteristics as the original part Unau;horized
svbstiluffons may resuh in additional damage to ;he uni_
• Upon completion of any service or repairs to ;his T_v
perform safely checks te determine that ;he TV is in
This device complies with part t5 of the FCC Rules
(1] This device may not cause harmful taterference,
(2] This device must accept any interference ;hat may
This television receiver provides displa_
;he FCC ru_es
FCC Information
User Instructions
The Federal Communications Commission Radio
Frequency _nlerference Slatement tac[udes ;he fok
lowing warning:
NOTE: This equipment has Been tested and found
1ocompty with ;he _imils for a Class B digital
device, porsuanl 1o Part 15 of ;he FCC Rutes
Tbese limits are designed to provide reasonable
protection againsl harmful interference in a resi-
dential installation This equipment generates,
uses, and can radiate radio frequencyenergy
and, if hal installed and used in accordance with
;he tastruclions, may cause bermful interference 1o
radio communications. However, ;here is no guar-
antee ;hat inlerference will not occur in a particu-
lar installation
If this equipment does cause harmful interference
ta radio or television receptions, which can be
determined by turning ;he equipmenl off and on,
;he user _s encouraged ta try 1o correct the interfe_
once by one or more of the following measures:
• Reorienl or refecale lhe receiving antenna
• Increase the separation baleen the equipment
and receive_
• Connecl ;he equipment into an out_e_ on a eta
cui_ different from that to which ;he receiver is
connected.
• Consult ;he dealer or an experienced radlo/TV
technician for help.
User information
Changes or modihcaltans hal expressly approved
by the party responsibte for compliance could
void the user's authority te operate ;he equipmenL
If necessary, consult your deaJel or an experi-
iflffenced [
Warning
User must use shielded signa_ interface cables to
maintain FCC compliance for the product¸
Declaration of conformity for products marked
with FCC Logo. This device complies with Part t5
of the FCC Rules¸
Opera,on is subiect to the following two condi-
_tans:
(1 ] this device may hal cause harmful interference,
and
(2] this device must accept any interference
received, including interference ;hal may cause
undesired opera_om
The party responsible for product compliance:
SAMSUNG ELECTRONICSCO, LTD
America QA Labof Samsung
85 West Tasman Drive
San Jose, CA 95134 USA
Tel) 408_544_5124
Paxj 408_44_5 _91
Provided with ;his monitor is a detachable power
supply cord with _EC320 style terminations¸ It may
be suitable for connec_on to any UL Listed person-
al computer with similar configuration¸ Before
making the connection, make sure the voltage ra_
ing of ;he computer convenience ou_et is the same
as the monitor and that ;he ampere rating of ;he
computer convenience oulJel is equal to or
exceeds the monitor voltage rating¸
Par 1 gO Voff applica_tans, use only UL Listed
detecbeb_e power cord with NEMA configuration
5-15P type (parallel blades} p_ug cap. For 240
Volt applications use only UL Listed Detachable
power supply cord with N£MA configuration
6015P type (tandem blades) plug cap
IC Compliance Notice
This Class _ digital apporalus meets aft require-
ments of the Canadian Interference-Caustag
Equipment Regulations of ICE_003
Notice de Conformit_ IC
Col appo_eil num6rique de dasse B respecte
loutes le_ exigences du R_gfemen_ICES-gO3 sur
los 6quipements prodeisan_ des interferences au
Canada