Memorizing The Channels - Samsung TX-S3082WH Owner's Instructions Manual

Memorizing the Channels
Your TV can memorize and store all of the available channels tk_rboth "off' air" (air) and cable channels.
After the available channels are memorized, use the CH A or CH V button to scan through the channels.
This eliminates the need to change channels by entering the channel digits. There are three steps tbr memorizing channels:
selecting a broadcast source, memorizing the channels (amomatic) and adding and deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the
TV (i.e. an air or a cable system).
1. Press the MENU button to display the menu.
Press the • or • button to select "Channel", then press the ENTER button.
2.
Press the ENTER button select "Antenna".
Press the • or • button to select "Air" or "Cable", then press the ENTER
button.
Press the EXIT button to exit.
Storing Channels in Memory (Automatic Method)
1. Press the MENU button to display the menu.
Press the • or • button to select "Channel", then press the ENTER button.
2. Press the • or • button to select "Auto Program", then press the ENTER
button.
3. Press the • or • button to select the antenna connection, then press the
ENTER button.
> Air: 'Air" antenna signal.
Cable: 'Cable" antenna signal.
Air+Cable: 'Air" and 'Cable" antenna signals.
If the antenna is connected to ANT 1 IN (AIR), select 'Air" and if it is connected to ANT
2 IN (CABLE), select 'Cable".
If both ANT 1 IN and ANT 2 IN are connected, select the 'Air + Cable".
If you selected 'Air", then go to step 5.
4. Select the correct signal source (STD, HRC, and IRC) by pressing the 4 button,
then press the • or • button.
Press the _- button to select "Start", then press the ENTER button.
STD, HRC, and IRC identify various types of cable TV systems. Contact your local
cable company to identify the type of cable system that exists in your particular area. At
this point the signal source has been selected.
5. After all the available channels are stored, the "Auto Program" menu reappears.
Press the EXIT button to exit.
AUTO PROG ADD/DEL MTS SRS
You can also press the AUTO PROG. button on the remote control to bring up the
Auto Program menu.
English- 17