RESTRICTED USE ONLY
Using the Flipper Offset option
Use this option to set the position of the flipper so that it is level with the card path.
Step
Procedure
1
Lower the lead-in of the Flipper Table (or offset the Flipper more clockwise) by
clicking on the down arrow to enter a negative value.
OR
Raise the lead-in of the Flipper Table (or offset the Flipper more counter-
clockwise) by clicking the up
Caution #1: Adjust only ±1 to avoid accidentally over-adjusting the
Flipper offset.
Caution #2: If the positive value is set too high, the Flipper angle may
be too high causing a card jam. (Maximum Range: The maximum adjustment
range is ±10.)
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0)
arrow to enter a positive value.
Fargo Electronics, Inc.
104