Opening The Display; Turn On The Computer - Panasonic Toughbook C1 Operating Instructions Manual

Cf-c1 series personal computer
Hide thumbs Also See for Toughbook C1:
Table of Contents

Advertisement

2
A
3
4
2

Opening the Display

A Hold the side of the computer with either of your hands and then hold and lift
the (A) part to open the display.
CAUTION
Do not open the display wider than necessary (130° or more), and do not apply
excessive pressure to the LCD. Do not open or close the computer holding the
edge of the LCD segment.
3
Connect your computer to a power outlet.
The battery charging starts automatically.
CAUTION
Do not disconnect the AC adaptor and do not switch the wireless switch to on
until the fi rst-time operation procedure is completed.
When using the computer for the fi rst time, do not connect any peripheral device
except the battery pack and AC adaptor.
Handling the AC adaptor
Problems such as sudden voltage drops may arise during periods of thunder
and lightning. Since this could adversely affect your computer, an uninter-
ruptible power source (UPS) is highly recommended unless running from the
battery pack alone.
4

Turn on the computer.

A Slide and hold the power switch
power indicator
lights.
When the power is turned on, the power indicator lights. But, in the fol-
lowing cases, the power indicator may turn off once immediately after the
power is turned on.
After removing the battery pack and the AC adaptor and setting them again
After sliding the power switch for four seconds or longer and turning off
the power
CAUTION
Do not slide the power switch repeatedly.
The computer will forcibly be turned off if you slide and hold the power switch for
4 seconds or longer.
Once you turn off the computer, wait for 10 seconds or more before you turn on
the computer again.
Do not perform the following operation until the hard disk drive indicator
Connecting or disconnecting the AC adaptor
Sliding the power switch
Touching the keyboard, touch pad, screen, external mouse, or tablet buttons
Closing the display
Any changes from the default setting of the Setup Utility must not be made until
the First-time Operation is completed.
for approximately 1 second until the
turns off.
15

Advertisement

Table of Contents
loading

Table of Contents