Genie TML-4000N Operator's Manual page 4

Operator's Manual
SAFETY RULES
Fall Hazards
Do not stand on the
machine.
Do not climb on the mast.
Tip-over
Hazards
Do not raise the mast to the vertical position unless
all outriggers are properly deployed, the foot pads
are in firm contact with the ground and the machine
is level.
Do not set the machine up on a surface where it
cannot be leveled using only the leveling jacks.
Do not hang any objects from the lights or mast.
Do not use the mast to raise material or personnel.
Do not move the machine unless the mast is
lowered to the horizontal position and securely
locked in place.
Do not extend the mast when wind speeds may
exceed 60 mph / 27 m/sec.
Do not place ladders or scaffolds against any part
of the machine.
Do not alter or disable machine components that in
any way affect safety and stability.
2
Do not adjust or stow the outriggers when the mast
is raised.
Do not use the machine on a moving or mobile
surface or vehicle.
Be sure the tires are in good condition and the lug
nuts are properly tightened.
Electrocution Hazards
This machine is not electrically insulated and will
not provide protection from contact with or
proximity to electrical current.
Maintain safe distances away from electrical power
lines and apparatus in accordance with applicable
governmental regulations and the following chart.
Voltage
Phase to Phase
0 to 300V
300V to 50KV
50KV to 200KV
200KV to 350KV
350KV to 500KV
500KV to 750KV
750KV to 1000KV
Allow for mast movement and electrical line sway
or sag, and be aware of strong or gusty winds.
Do not operate the machine during lightning or
storms.
Do not use the machine as a ground for welding.
Genie TML-4000 and TML-4000N
Third Edition • Second Printing
Minimum Safe
Approach Distance
Feet
Avoid Contact
10
15
20
25
35
45
Part No. 97600
Meters
3.05
4.60
6.10
7.62
10.67
13.72