Advertisement
Note: Replace the dust bag even if it is not full ( the
pores may be blocked with fine dust particles ) also
replace after using to collect carpet cleaning powders.
Always operate the cleaner with the dust bag installed.
Use only genuine replacement bags. Dust bag Part
Number E51N.
Warning: On collection of proprietary carpet
conditioning powders, plaster / concrete dust, it is
recommended that the dust bag is changed.
Some of the preparations contain substances
which while left in the vacuum cleaner for
extended periods, could create damage. Many
air fresheners, household deodorants, sprays
and polishes contain highly inflammable gas
propellants. Because of this it is particularly
important that these products are used strictly
in accordance with the relevant manufacturers
instructions. It is essential that none of the above
products are sprayed directly into the vacuum
cleaner or any of the filters, hose assembly
or dust chamber.
Spares
New filters and dust bags can be obtained from
your Authorised Electrolux service provider. In the
Booklet enclosed with this cleaner.
Please specify the model of the cleaner on
ordering parts.
INSTRUCTIONS FOR USE
5.
Cleaning the motor filter
It is recommended that the motor filter should
be cleaned approximately twice a year or when it
becomes visibly soiled with the cleaner
being used more frequently.
1. Remove the dust bag from the holder and take
out the motor protection filter, if soiled wash
the filter
2. Rinse the filter under lukewarm tap water and
ensure it is dry before inserting it back into
the cleaner.
3. Insert the filter into position, fit the dust bag
into the holder refit the dust bag and press
close the dust compartment cover.
Replacement Motor Filter Part
Number: EF1
Replacement of the micro exhaust filter ( Z1550 )
It is recommended that the micro exhaust filter is
replaced every four months.
1. Release the catch at the rear of the filter grille
and lift it off the cleaner. To remove the
micro filter.
MAINTENANCE
2. Remove the filter and frame assembly, take the
micro filter out of the frame and insert a new one.
3. Refit the micro filter and frame assembly into
the cleaner.
4. Fit the filter grille into position and press down
to lock into place.
Replacement Micro filter Part
Number EF2
Replacement of the HEPA exhaust filter ( Z1560 )
It is recommended that the HEPA filter is changed
once a year or when heavy soiling is visible,
depending on the use of the vacuum cleaner.
1. Release the catch at the rear of the filter grille
and lift it off the cleaner. to remove the
HEPA filter.
2. Remove the HEPA filter assembly, and insert a
new one.
6.
Advertisement
