Electrolux EDC 77570 W User Manual page 11

125987340.qxp 2007-03-16
press one of the option buttons or turn
the programme selector.
A A l l a a r r m m c c o o d d e e
In case of a functional anomaly, the
display
shows an alarm code (e.g. E21).
" " D D r r y y i i n n g g " "
This symbol appears on the dispay that
the appliance is in the drying phase.
" " C C o o o o l l i i n n g g " "
This symbol appears on the dispay that
the appliance is in the cooling phase.
At the end of drying, there is a 10
minute cooling phase to cool the
laundry.
" " L L o o n n g g A A n n t t i i c c r r e e a a s s e e " "
This symbol appears on the dispay at
the end of the cooling phase, during
the anti-creasing phase and at the end
of the programme.
I I n n d d i i c c a a t t o o r r l l i i g g h h t t s s
These lights indicate the following
functions:
"Water reservoir full" light
This light comes on at the end of the
programme to remind you that the
water reservoir must be emptied out. If
this light illuminates during a
programme this means
that the water reservoir is full. The
buzzer sounds, the programme stops,
the light of the Start/Pause button
flashes. "Filter cleaning" light
It comes on every 80 cycles to remind
you that the condenser must be
cleaned. "Condenser cleaning" light
This light illuminates at the end of the
programme to remind you that the
filters must be cleaned.
A A t t t t h h e e e e n n d d o o f f t t h h e e p p r r o o g g r r a a m m m m e e
All drying programmes end with a 10
minute cooling phase. You may remove
11:42 Page 11
the laundry after this phase. The lights
and ,
The display shows a static zero. If the
laundry is not removed at the end of
the cycle, the dryer performs an anti-
creasing phase (duration: 30 minutes
maximum).
If you do not remove the laundry, the
dryer will stop automatically at the end
of
the anti-creasing phase. Lights
remain lit and the buzzer
sounds for 2 minutes. If you do not
intend to carry out another wash, close
the water tap. Leave the door open to
prevent the formation of mildew and
unpleasant smells.
Turn the programme selector dial to
"O" to switch the machine off. Remove
the laundry from the drum and carefully
check that the drum is empty. The
appliance is switched off.
Remove the laundry.
I I f f y y o o u u o o p p e e n n a a n n d d t t h h e e n n c c l l o o s s e e t t h h e e d d o o o o r r
b b e e f f o o r r e e t t u u r r n n i i n n g g t t h h e e s s e e l l e e c c t t o o r r d d i i a a l l t t o o " " O O " "
a a l l l l t t h h e e l l i i g g h h t t s s c c o o r r r r e e s s p p o o n n d d i i n n g g t t o o t t h h e e
p p h h a a s s e e s s m m a a k k i i n n g g u u p p t t h h e e p p e e r r f f o o r r m m e e d d
p p r r o o g g r r a a m m m m e e c c o o m m e e o o n n . .
A A f f t t e e r r e e a a c c h h u u s s e e
• Clean the filters.
• Empty the water reservoir
I I m m p p o o r r t t a a n n t t ! !
If the drying programme has to be
stopped before it reaches the end, we
recommend that you turn the pro-
gramme selector dial to position
Cooling
this cooling phase before removing the
laundry. This will avoid a build-up of
heat inside the appliance.To do this
first turn the dial to "O O " and then to
Cooling
M M o o d d i i f f y y i i n n g g t t h h e e p p r r o o g g r r a a m m m m e e
To change a programme which is run-
ning, first cancel it by turning the pro-
gramme selector dial to "O". Select the
new programme and press the Start
button.
use electrolux 11
illuminate.
and
and wait until the end of
and depress Start button.
G G B B